Hello everyone,
Installing a new D&D input shaft on T56. The issue is it roates freely until 180* point then feels like slight jam until it passes that point. Its consistant each time same pleace. Installed old Input shaft and roates freely. Swaped it back and forth a few times with same results. Bearing was pressed in by D&D.
Local Mustang shop took a look and spun it by hand and think its most likely burr on the teeth. They said it happened to then 2 times last year with D&D shaft, and they had to file the burr to get it smooth..
Im going to call D&D monday, anyone ever had a smiliar issue?
Installing a new D&D input shaft on T56. The issue is it roates freely until 180* point then feels like slight jam until it passes that point. Its consistant each time same pleace. Installed old Input shaft and roates freely. Swaped it back and forth a few times with same results. Bearing was pressed in by D&D.
Local Mustang shop took a look and spun it by hand and think its most likely burr on the teeth. They said it happened to then 2 times last year with D&D shaft, and they had to file the burr to get it smooth..
Im going to call D&D monday, anyone ever had a smiliar issue?