installed magnum xl, wiring help needed

[Coyote'13]

I installed the magnum xl but need some info on the wiring since no diagrams were provided. Can someone identify the 3 connectors on the mt82 vs the tremec magnum xl?


This is what I figured is on the mt82.


1) Skipshift solenoid right side near shifter mount housing.


2) left side rear housing, reverse light switch?


3) speed sensor bottom right of transmission


Here's the tremec


1) reverse lockout; left side of shifter. Do I just need to need a 12 volt power source like the brake light or something for this?


There are 2 sensors on the right. I think the one near the tail housing is the speed sensor??? What is the plug near the bell housing for?


Anyone have experience wiring this or have a place I can get the wiring diagrams. I know theyre fairly simple circuits but I just need to make sure I know what is what. Thanks

 

[Coyote'13]

Ok I figured out on the tremec the sensor near the bell housing is the reverse light, the one near the tail housing is clearly the speed sensor.

thoughts on where to tap into for the reverse lockout and Abbott box?

 

[Coyote'13]

Thanks for the help guys. Good to go

 

[gimmie11s]

Lol