Finally got the 26 spline input shaft installed after waiting FOREVER for parts. Needed a .036" shim to make the input shaft bearing work, kit only had 21, 30, 33, 40 and on up shims! I was tired of waiting on parts, so I sanded (yes it sounds redneck) the .040" shim down to .036" to make it work. I was skeptical at first, but the sanding ended up being even, mic'd it in 8 locations.
What grease does everyone use inder the TOB sleeve, and on the clutch fork?
What grease does everyone use inder the TOB sleeve, and on the clutch fork?