I have swapped Terminator engine in my 1994 Cobra, project is nearly finished. I have 2003 original repair manual and Alldata access but I can't find where Boost sensor wires are connected, or what kind of signal they are giving. I have Mach1 ecm, and I'm using IAT2 instead of IAT in maf sensor, so I can adjust spark according to that. I can connect boost signal to dpfe signal for logging, if it has analog curve. Apparently ECM won't even use boost signal, I searched Terminator calibration in Binary Editor and there is no transfer curve, is it only used foor boost gauge in cluster?
Does anyone have more information?
I found connector picture and iat swap help, but not boost signal specs
Mustang Matt's guide to the 03/04 Terminator swap
Does anyone have more information?
I found connector picture and iat swap help, but not boost signal specs
Mustang Matt's guide to the 03/04 Terminator swap
Last edited: