I'm in the process for hooking up my dynojet wideband and I can't seem to find a place to pick up the rpm signal. I know that it says to get the signal from the coil on plug but where and which one or am I all wrong here?
Help with DYNOJET wideband
- Thread starter S/CCobra03
- Start date
Go to this link: http://www.raptorperformance.com/99+_Mustang_Install.htm
This is the install procedure for the Raptor Shift Light, but it also requires to tap into the RPM signal wire. These instructions have good pictures to show you which wire you need to tap into for the RPM signal.
This is the install procedure for the Raptor Shift Light, but it also requires to tap into the RPM signal wire. These instructions have good pictures to show you which wire you need to tap into for the RPM signal.
Thanks for the quick reply and for the helpful info. I'll check it out.
For RPM you will need to tap into Pin #26 off of the PCM. I have a PCM Pin# guide if you need it PM me and I will email it to you. The TPS can also be wired up off of the PCM. ANy Questions let me know.
http://www.svtoanashville.com/forums/showthread.php?t=117
My short wrtie up on our local site that i thought you might wanna see.
My short wrtie up on our local site that i thought you might wanna see.
Last edited:
97topless snake can you post the pin#guide that you have? I just bought a WBC too and would definately appreciate the help.
Modded Mystic said:
The pin guide that I have is in PDF. format so I can only email it to ya. PM me your email address and I will shoot it to ya. It is a big help on the install. THe RPM wire is number 26 light green and white but with out the pin diagram it is hard to figure out where #26 is.
Users who are viewing this thread
