help for SHO

rcombs1

New Member
Joined
May 10, 2012
Messages
4
Location
kentucky
Hey guys I am brand new here. Just sold my 86 mustang GT and bought a 93 SHO atx. I love this car. Need some help...
The car was missing and idling rough. It still had original plug wires so I replaced the wires and plugs. Also replaced a couple vacuum lines. The car ran smooth for a while but now it bucks like a wild horse and has significant power loss. Where do I go from here. No check engine light but maybe it has been disconnected by previous own:shrug:
 

NEp8ntballer

Member
Established Member
Joined
May 6, 2012
Messages
208
Location
Lousyana
make sure the plug wires are routed properly and that if you disconnected anything that it was plugged back in. if the tach is acting funny when it runs rough then the cam position sensor is on the way out. Post on www.shoforum.com as it gets more traffic than the SHO section here.
 

zblackbeast

New Member
Established Member
Joined
Oct 1, 2012
Messages
8
Location
Plymouth, CT
What plugs did you use? The SHO likes the Autolite/Motorcraft and Denso plugs (yamaha motor).

Also, check your CAM sensor and DIS module.
 

Users who are viewing this thread



Top