Probably a long shot by how tight the 1 inch Magnuson heat exchanger fits in there(and it's pushed all the way back), but do any other heat exchangers fit behind this bumper without hacking it up too much?
Mainly I don't want to cut the 2 "ribs/supports" in the lower opening.
I don't need fans, so I can possibly set them back with washers/nuts.
I was looking at a take off 13-14 GT500 heat exchanger as a potential, or a fanless C&R.
Mainly I don't want to cut the 2 "ribs/supports" in the lower opening.
I don't need fans, so I can possibly set them back with washers/nuts.
I was looking at a take off 13-14 GT500 heat exchanger as a potential, or a fanless C&R.