• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

H&r Springs

Discussion in 'New Edge Cobras' started by NAPERCOBRA, Jun 3, 2004.

  1. NAPERCOBRA

    NAPERCOBRA Active Member Established Member

    Messages:
    213
    Joined:
    May 30, 2003
    Location:
    Mommies house
    GETTING READY TO INSTALL LOWERING SPRINGS AND I HAVE A QUESTION ABOUT RE-INSTALLING THE SPRING ISOLATORS I WANT TO REMOVE THEM BUT I WANT TO KNOW IF THERES A DOWN FALL TO THIS. SHOULD I REMOVE THEM OR KEEP THEM ON.:)
     
  2. REX-RACER

    REX-RACER Testing w/ the live data! Established Member

    Messages:
    3,670
    Joined:
    Jan 16, 2004
    Location:
    H-town by way of STL
    Get new ones, preferably made of urathane. Apparently the stock rubber ones compress a lot. Nearly everything I've read says to replace them when you do the springs and/or shock.

    Read this . . .
     
  3. SVT Chic

    SVT Chic New Member Established Member

    Messages:
    263
    Joined:
    Mar 16, 2002
    Location:
    Maryland
    I didn't change anything and it's fine
     

Share This Page