Posi Port #210 comes with Eaton, 2 BF pulley rings, 1 hub (2.76 and 2.93 (new)), ported tb and plenum, all sensors/gaskets, supposedly 2k miles since rebuild/port-$1200 shipping/pp included.
Last edited:
FS: Posi Ported Eaton #210 w/ matching plenum, TB and 2 Billetflow pullies
- Thread starter Huff035
- Start date
Never got to dyno it, car was hit by some idiot before I took it. This is part of my part out.
With his setup it should have been in the 520ish range at the tires on 93. More to be had with a bigger TB/Plenum setup.
I have a accufab tb/plenum. Could this blower with a 4/6lb lower make 550ish?
Posted via Topify using iPhone/iPad
Posted via Topify using iPhone/iPad
Depends on the fuel. Mine makes 552 with a 2.9/6lb setup on E-85.
without E85, no way. with a lower you will break 5 but with an upper only you will probably be just under or around 5.
My car made 481 as it sits. So how much do you pick up with a ported blower and a 4/6lb lower?
Posted via Topify using iPhone/iPad
Posted via Topify using iPhone/iPad
A friend of mine made 519hp 520tq with a 2.93 upper and 4lb lower. and 530/550 with a 2.76 and 4lb lower. On a posi.
Will throw in a 4lb metco lower kit w/ a 3.2 alternator pulley and a gatorback belt for an extra $250.
Will throw in a 4lb metco lower kit w/ a 3.2 alternator pulley and a gatorback belt for an extra $250.
Last edited:
Same day of tuning my car made 530 on 93. That was the first tune, then we did the E-85 tune. The extra hp and torque is great. The fact that it is much more consistent than the 93 is the best part
If I could get to 530rwhp that might keep me content until I could get a Whipple.
Posted via Topify using iPhone/iPad
Posted via Topify using iPhone/iPad
Would you consider selling the 2.76 pulley alone?
No, sorry, want to keep it together.
Bump..
to the top!
bump
to the top! price is OBO.
To the top!
Users who are viewing this thread
