FS Metco Auxillary Idler and bracket 90mm

stanggirl14

Member
Established Member
Joined
Sep 15, 2010
Messages
655
Location
Fayetteville, NC
SOLD!!!

I got a set of double bearing idlers so selling the one I had on my car.

It's a metco 90mm single bearing idler with bracket, idler has approximately 10k miles on it but I replaced the bearing and snap ring yesterday with a new one from metco motorsports so the bearing itself has 0 miles. Does have a couple small nicks from install but nothing on the surface that would affect the belt, works perfectly, pulled from my car yesterday.






 
Last edited:

stanggirl14

Member
Established Member
Joined
Sep 15, 2010
Messages
655
Location
Fayetteville, NC
Bump it up

No one needs an aux idler? I know it's a 90mm but I ran this on my car with a 6lbs lower and 2.76 upper without a problem, no belt slip. Only swapped it out b/c I got a double bearing kit.
 

Users who are viewing this thread



Top