Fore return style

[Johnferris]

what's up guys I got the level 2 fore return style fuel system and I'm about to wire it in.. question What color wire do you tie in from the fuel hat to the cars harness? Or does anyone have a link to a write up on here iv seen many but I don't know what ones to follow the best. Any help would be greatly appreciated

 

[MG0h3]

https://www.svtperformance.com/foru...-allowing-oe-type-fuel-pump-actuation.825181/

Here you go. Believe the first post was updated with the final results.

The system should have come with a 4 wire harness from the pumps that will run to the relays (or controller if you went that route).

 

[Bdubbs]

Below you can see the factory wiring harness connected to the fore wires. Yellow to yellow, black to black.

 

[MG0h3]

good call Bdubbs. Forgot that thread probably doesnt address the sender wires.

 

[Johnferris]

feed the front red/black or the back coming off the hat. how do you know which ones are for feeds and which ones are for the returns

 

[MG0h3]

I dont understand the question. Are you referring to power or fuel feed?

The hat is marked for feed and return regarding the lines.

You wont use any factory wires for feeding the pumps between the hat and the relay/controller. You can see the big grey connector coming off the hat. The included harness has the other end and 4 wires (2 red/2 black) that will run up to the relay/controller.