Dyno numbers from my vert !!

[KINGCOBRA86]

Been a long time since it ran good, but the hard work is paying off , all work done by me I also tuned it my self on the street and rented a dyno to see how she doing .

quick run down

Big bore boss 323ci compression 9.75
Fox lake heads bullet cams
Crappy hellion hot side
Pte 76/75
4"down pipe
Custom cold side 3.5 pipes
Freddy brown 4r70w
E85
On 18lbs it made 830 whp to the tire on the 1st pull
Try running it up to 30lbs but spark blow out happens after 26lbs

 

[Shadow Grey 03]

Damn. Should be fun.

 

[03_uni-B]

That will be rowdy.

 

[LordVader04]

Badass ride man, What upper/lower intake are you running?

 

[badcobra]

Good numbers man.

Can you share what you are using to secure your bumper and what hood? Thanks

 

[lilmarauder]

X2 on the intake manifold setup. Hope my ported short runner does that good.

Sent from my SM-G900V using Tapatalk

 

[KINGCOBRA86]

Good numbers man.

Can you share what you are using to secure your bumper and what hood? Thanks

There quick latches I cut off the factor tabs on the bumper and uses the holes on the car were the bumper would bolt to super easy took a hr

Guys it a ported 6" runner from Roy on Mach 1 forums

 

[badcobra]

What hood is that? I like it. Thanks

 

[KINGCOBRA86]

What hood is that? I like it. Thanks

Vfn Cajun bolt on

 

[4sdvenom]

Great numbers man. Love the hood too, could you post a few more pics from different angles of it? I have been kicking around getting that hood for a while but wanted to see more pics of it on an actual car and painted.

Thanks,
Ken

 

[KINGCOBRA86]

Great numbers man. Love the hood too, could you post a few more pics from different angles of it? I have been kicking around getting that hood for a while but wanted to see more pics of it on an actual car and painted.

Thanks,
Ken

I'll try and get some this weekend

 

[stradt03]

whoooooweeeeeee, 30psi on that Boss block?!??

What kind of head hardware did you use to keep it sealed up?

 

[KINGCOBRA86]

We deck the block and heads put arp 2000 studs at 120lbs with comitic gaskets

 

[stradt03]

We deck the block and heads put arp 2000 studs at 120lbs with comitic gaskets

NICE! I have the 2000s torqued to 100lbs but I'm not running anywhere near 30psi.

 

[KINGCOBRA86]

NICE! I have the 2000s torqued to 100lbs but I'm not running anywhere near 30psi.

The most it see is 26lbs once I figure out my back pressure issue I'll crank here up