dw400

thelonebean

Just a slow 99
Established Member
Joined
Sep 12, 2019
Messages
289
Location
California
Just out of curiosity, has anyone tried to use a dw400 pump in a 99-04 fuel hat? I was thinking of running one just as overkill but I'm wondering if its too big to fit inside the plastic assembly.
 

Blkkbgt

Well-Known Member
Established Member
Premium Member
Joined
Feb 3, 2011
Messages
2,118
Location
The land of commies and socialists!
It’s 46mm instead of the standard 39mm wide
I was more concerned about the height. I honestly can't remember enough about my old GT basket to tell you it will work for sure. I would anticipate having to modify it.

The GT tank and pump assembly is really not that great and I highly recommend you look into a cobra twin pump setup if possible.
 

thelonebean

Just a slow 99
Established Member
Joined
Sep 12, 2019
Messages
289
Location
California
I was more concerned about the height. I honestly can't remember enough about my old GT basket to tell you it will work for sure. I would anticipate having to modify it.

The GT tank and pump assembly is really not that great and I highly recommend you look into a cobra twin pump setup if possible.
I would think I’ll have to modify it to fit but I didn’t know if anyone knew exactly how much. I know the gt stuff is limiting and I actually have a cobra tank and a dual pump hat from division x I could put on in the mean time. I’d just have to plug the return port, adapt it to the stock line and use the aftermarket wiring harness. But with that much effort, I’d almost rather install the whole return system than jerry rig it to work with stock lines and fuel rails.
 

Blkkbgt

Well-Known Member
Established Member
Premium Member
Joined
Feb 3, 2011
Messages
2,118
Location
The land of commies and socialists!
I would think I’ll have to modify it to fit but I didn’t know if anyone knew exactly how much. I know the gt stuff is limiting and I actually have a cobra tank and a dual pump hat from division x I could put on in the mean time. I’d just have to plug the return port, adapt it to the stock line and use the aftermarket wiring harness. But with that much effort, I’d almost rather install the whole return system than jerry rig it to work with stock lines and fuel rails.

If you have all that ready to go I'd say F that single pump and just go all in on the new stuff.
 

Users who are viewing this thread



Top