Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
Driveshaft spacer for '03 Cobra flange
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Wings65288" data-source="post: 16717976" data-attributes="member: 23678"><p>I think the sonnax slip yoke has an engagement of 4.75 inches and i have almost 2 inches sticking out of the trans.</p><p></p><p>Pinion angle was set at -2 but I'm going to double-check that.</p><p></p><p>Good call on the rear setup, i was actually going to put my slicks on when i get home and triple-check theyre centered in the wheel-well. </p><p></p><p>When I was home i remeasured from the seal of the tailshaft on the tranny (right where the sonnax slip yoke enters) to the flat side of the pinion flange on my 8.8" and i was getting 48.75".</p><p></p><p>Here's a few pics[ATTACH=full]1734070[/ATTACH][ATTACH=full]1734071[/ATTACH][ATTACH=full]1734072[/ATTACH]</p></blockquote><p></p>
[QUOTE="Wings65288, post: 16717976, member: 23678"] I think the sonnax slip yoke has an engagement of 4.75 inches and i have almost 2 inches sticking out of the trans. Pinion angle was set at -2 but I'm going to double-check that. Good call on the rear setup, i was actually going to put my slicks on when i get home and triple-check theyre centered in the wheel-well. When I was home i remeasured from the seal of the tailshaft on the tranny (right where the sonnax slip yoke enters) to the flat side of the pinion flange on my 8.8" and i was getting 48.75". Here's a few pics[ATTACH type="full"]1734070[/ATTACH][ATTACH type="full"]1734071[/ATTACH][ATTACH type="full"]1734072[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
Driveshaft spacer for '03 Cobra flange
Top