I installed a IAC plate on the 01 cobra with two 5/16 holes to stop the rev hang between shifts. Car starts fine, revs come down perfectly with shifts, no stalling at all.
Only problem is the idle hangs around 950-1050 , it stays high now.
I disconnected the battery to reset KAM hoping this would help adjust it. Didn’t work.
Is there an idle screw to adjust?
Also curious- is 1 of the 2 holes on the IAC plate I installed supposed to be bigger? I cut both holes the same size. I see people selling these where 1 Hole is bigger.
Only problem is the idle hangs around 950-1050 , it stays high now.
I disconnected the battery to reset KAM hoping this would help adjust it. Didn’t work.
Is there an idle screw to adjust?
Also curious- is 1 of the 2 holes on the IAC plate I installed supposed to be bigger? I cut both holes the same size. I see people selling these where 1 Hole is bigger.