• Welcome to SVTPerformance!

Custom ProCharger D1SC Kit

Discussion in 'Engine/Drivetrain' started by SmokeGreyHatch, Feb 9, 2015.

  1. SmokeGreyHatch

    SmokeGreyHatch Member Established Member

    Messages:
    544
    Joined:
    Aug 8, 2006
    Location:
    Gilbert, AZ
    Selling the blower kit I had on the 6.2 SOHC swap I had in the stang for less than 500 miles. This can be used on any Raptor or 6.2 SD/F-150 as a non-intercooled application or used to build your own air-water or air-air setup. You could also fab a sheetmetal upper on a whipple/roush lower as well. Lot's of possibilities with this kit and this will be offered way below what a ProCharger kit costs. Here is what is included, all parts were purchased new and have less than 500 miles:

    ProCharger D1SC head unit, satin, 3.85 pulley
    3/4" thick main bracket with idler pullies and manual tensioner - all bolts and spacers included
    Two belts, one of them is a Gates green
    multiple ply silicone hose adaptors, black
    T-bolt clamps for all connections
    ProCharger "big red" race blow off valve on a custom 45-degree bend
    Inlet tubing, solicone hose, clamps, and K&N filter

    This setup made 700 rwhp on 10 psi through a stick. Head unit will support over 900 hp.

    blowersetup.jpg

    Looking to get $3500 shipped.

    Thanks,

    Matt
     
  2. JSpeed71

    JSpeed71 Mod Motor Junkie Established Member

    Messages:
    60
    Joined:
    May 17, 2004
    Location:
    Florida
    Msg sent to ya!
     
  3. SmokeGreyHatch

    SmokeGreyHatch Member Established Member

    Messages:
    544
    Joined:
    Aug 8, 2006
    Location:
    Gilbert, AZ
    Sold! Enjoy the kit, John. Thanks SVTP
     

Share This Page