• Welcome to SVTPerformance!

Creating my own Stainless Works exhaust - need help

Discussion in 'Exhaust' started by 02_Lightning, Dec 31, 2015.

  1. 02_Lightning

    02_Lightning Active Member Established Member

    Messages:
    1,195
    Joined:
    Jan 28, 2001
    I am going to get an S-Tube muffler from them and then get a Magnaflow single in, dual out adapter. Since the muffler is oval like factory, need help with how to specify the the inlet and outlet locations. I was thinking they should both be offset and offset to the same side. This will get it away from the driveshaft. Any ideas?
     
  2. SuperMarioSVT

    SuperMarioSVT Kiss of Death Established Member

    Messages:
    1,012
    Joined:
    Aug 21, 2011
    Location:
    Chicago, IL
    You're better off posting on FRF (Ford Raptor Forum) rather than here. This section is very dead..
     
  3. 02_Lightning

    02_Lightning Active Member Established Member

    Messages:
    1,195
    Joined:
    Jan 28, 2001
    Thanks. I didn't like FRF... many arrogant snots over there and the forum is very poorly run. So, I don't hang out over there after how they treated people. no thanks.
     
  4. SuperMarioSVT

    SuperMarioSVT Kiss of Death Established Member

    Messages:
    1,012
    Joined:
    Aug 21, 2011
    Location:
    Chicago, IL
    Totally agree with you. I wish this part of the forum was more lively unfortunately it's not..
     
  5. DriftwoodSVT

    DriftwoodSVT Raptor club member Established Member

    Messages:
    6,386
    Joined:
    May 27, 2006
    Location:
    Driftwood, TX
    Agreed. FRF is a superior resource for information. I'm on there daily.
     
  6. HalfTime

    HalfTime Race it how you drive it. Established Member

    Messages:
    3,162
    Joined:
    Dec 28, 2005
    Location:
    Yuma, AZ
    Yep.
     

Share This Page