Hello all, I’m installing Paxton 2200 to 2014 mustang gt. I was about to put blower in and the pulley is too small 3.33....I have a 3.8 I need to put on but can’t seem to break bolt on blower. I put some vice grips on and pb blaster and I can’t budge....I was going lefty Lucy is that the correct way? I got pry bar on it but was afraid I might strip bolt out.....Any tricks??
Change pulley Paxton 2200
- Thread starter Go551
- Start date
Get an impact. Or maybe a strap wrench.
Yup, had to use strap wrench and impact to get off.....Then I used gear puller to take pulley off....thanks for the advice guys
Users who are viewing this thread
