Car is running sluggish and has a intermittent p0358 code

[Dark_Times]

I am having the same problem I wondefing if I pinched a wire when I install the vmp 2.3 tvs on my 04 cobra its frustrating too any help would be greatly appreciated for sure
Reference thread.
https://www.svtperformance.com/thre...sh-and-has-a-intermittent-p0358-code.1097852/

 

[me32]

Mods?

 

[nxhappy]

the coils NEED to be factory motorcraft. for plugs NGK or MC.

 

[Dark_Times]

The mods are vmp 2.3 tvs with accufab tb, 60lbs injectors,c&l cold air intake 2.8 upper pulley, stock lower 3000maf sensor, bost a pump just replace the fuel pumps to gt super pumps, magna flow catback with mid pipe. Other than that I have ngk plugs gap too .28 and rest is pretty much stock

 

[nxhappy]

test each coil OHMS individual ...replace ONLY with OEM brand

 

[Dark_Times]

Thanks I'll have to give it a try this weekend i hope is an easy fix. Where I won't have to take the whipple back off to make sure I didn't pinched a wire putting it back on.

 

[hotcobra03]

Bumped an old thread.

But. If you haven’t

Try swapping 7/8

See if code changes

Main engine connection c133 has 10mm bolt.

Look and see if pin is bent or pushed in.

 

[Dark_Times]

Bumped an old thread.

But. If you haven’t

Try swapping 7/8

See if code changes

Main engine connection c133 has 10mm bolt.

Look and see if pin is bent or pushed in.

 

[Dark_Times]

Try swapping 7/8 stays on 8 still just dont puzzled Alitalia and when you say c133 connection to the main you talking about where the main harness connection before you put the lower intake with the super charger on?

 

[hotcobra03]

Try swapping 7/8 stays on 8 still just dont puzzled Alitalia and when you say c133 connection to the main you talking about where the main harness connection before you put the lower intake with the super charger on?

Passenger side firewall

Depending how much you moved you may not have pulled this connection

Only 1 with a bolt holding it

I had issues with po340. After some work.

With a multi meter I found it probing from c133 to sensor

It was a stretched wire from pulling connection by wire to remove.

All me but easy to find doing basic wire check

 

[Dark_Times]

Passenger side firewall

Depending how much you moved you may not have pulled this connection

Only 1 with a bolt holding it

I had issues with po340. After some work.

With a multi meter I found it probing from c133 to sensor

It was a stretched wire from pulling connection by wire to remove.

All me but easy to find doing basic wire check

 

[Dark_Times]

Thanks guys for all the help and reply maybe it would be a simple fixed just so frustrated lol