Cam Degreeing, Install question. Need advice.

darreng505

New Member
Established Member
Joined
Dec 28, 2012
Messages
1,314
Location
Washington, DC
Hi,
So what is the standard process for installing/degreeing a set of custom cams to get the best power curve?
I have 2012 Boss 302 and bought some custom cams with lockouts. The installer just used the default values
on the cam cards and put the car back together. The power curve is poor.

Should they have done a trial and error process with the cams open to degree them properly irrespective of
the cam cards?

How is this normally done? Or should have been done? Is the install normally done while on a dyno to get the power numbers?

Need advice. Thanks.
 

Users who are viewing this thread



Top