anyone in east texas area needing a built motor ? its basically a low compression aluminator, only with arp main studs. this is the original motor out of my grn13. it was pulled because bought aluminator to replace it. decided to do a coyote swap fox after fitting it in. I went ahead and put forged internals in it because I didn't want to pull it back out again (pita). I recently sent grn13's motor to be sleeved and now it will be going into coupe and grn13 will be going back stock.
looking to trade for stock motor + cash.
9.5 to 1 mahle pistons
eagle rods'
arp mains
boss valve springs
2013 block and heads
tss oil pump gears
idle time only.
4k plus stock motor obo
936-414-3111
want to do something pretty quick, I just pulled motor from coupe tonight.
looking to trade for stock motor + cash.
9.5 to 1 mahle pistons
eagle rods'
arp mains
boss valve springs
2013 block and heads
tss oil pump gears
idle time only.
4k plus stock motor obo
936-414-3111
want to do something pretty quick, I just pulled motor from coupe tonight.
Last edited: