Building Motor for new HP Kit

[10SecCobra]

I ordered my HP TT kit i got the GT35 ball bearing kit, i was hoping someone knows what cams are a good replacement to go with. i was gonna order Crower Stage 3. Any input on this or other cams woudl be nice. any any opinions on the other internals as well but i think i have that pretty much covered. here what im getting

Oliver Billet I beam Rods
Crower titanium spring s and retailers
CP pistons 20 over
1mm oversized valves by Crower
stainless steele rings
oil pump with billet gears
7qt canton oil pan with windage tray
then the necessary ARP Bolts

 

[postban]

Sounds good, best suggestion I could give is to find a Teksid block, they have better cooling than the iron block, something about the siamesed bores for 2-3 and 6-7.

Some middle holes have been going out on the built motors due to this.

Top and side Coated Diamond pistons may do better in the hot little motor we run

I suggest waiting on the cams, no one has hard data on what turbos want in this mill. Stock cams make stupid numbers and save a bit of cash.