Bolt size/spec Trans to Cross Member

[Corbic]

Anyone have this?

Thanks

 

[Wings65288]

Mustang Transmission Crossmember To Frame Bolts (99-04)

I have the Stifflers setup, heres the bolts, can't find the size tho

 

[Corbic]

Need that bolt, which is a different size then the xmemeber to chassis

 

[Wings65288]

I usually pull it out and take it to the fastener section of the hardware store. Ours has one of those templates where u screw the bolt into it and find the size that way

 

[Corbic]

I usually pull it out and take it to the fastener section of the hardware store. Ours has one of those templates where u screw the bolt into it and find the size that way

I would, accept I don't have one...

 

[DSG2003Mach1]

I usually pull it out and take it to the fastener section of the hardware store. Ours has one of those templates where u screw the bolt into it and find the size that way

I bought one for my garage, super handy lol

 

[olympic]

LMR sells exact replacements with the flanged head if you can't find them local. Mustang Transmission Mount Bolt Kit (79-04) - LMR.com

 

[hotcobra03]

It’s only a bolt. Not much to pick from.

M12-m14.

Pitch 1.25/1.50

Just basic metric bolts.

M10 are the sides smaller bolt.

Ford part sites list hardware used.

 

[Blkkbgt]

@Corbic

I am trying to upload a few photos but its M14x2.0 35mm long. Checked with a thread gauge and micrometer.

I measured the amount of thread protrusion through the mount ear and you can easily get away with a shorter 25mm or even a 20mm bolt. 20mm of threads stick out past the ear on the back.

Metric flange bolts, Full thread, Class 10.9 steel plain finish, 14mm x 2.0mm - Bolt Depot

 

[olympic]

I've edited my previous post because those were the dimensions of the crossmember to chassis bolts.

My car was on the hoist anyways so I pulled the bolt out and measured it. It took a bit to figure it out because M14x2.0 is very close to SAE 1/2" NC13. So I brought out a caliper and the tap and dye set and it's definitely SAE 1/2" NC13, 1.5" long. I snapped a couple pics of the caliper readings showing it's quite a bit smaller than 14mm diameter.