BF Pulley set + Hub and 2.76 Upper

layzie

Active Member
Established Member
Joined
Nov 29, 2009
Messages
255
Location
USA
Hello,

I have a complete BilletFlow Pulley set all Black in color The entire set (everything I am selling) has somewhere between 500-1000 miles on them.

Color: Black

Includes:

Bracket
One 92mm Billet Pulley
Three 100mm Billet Pulleys
All required bolts for installation which were supplied by BilletFlow
2.76 Upper Non slip pulley ring with hub for Eaton
Gates Belt perfectly sized for everything.

If anyone is interested, I Will sell it all for $350 shipped.

Thanks,
Layzie
 

mec03svt

SomethingVeryTechnical
Established Member
Joined
Sep 30, 2009
Messages
768
Location
Glen Mills, PA
I guess I'll be the first asshole to ask if you will part it haha. I would just need the bracket and hardware if you have it and decide to split up the set.
 

layzie

Active Member
Established Member
Joined
Nov 29, 2009
Messages
255
Location
USA
That was funny lol


I am in no rush to sell but there will be some like you who want pieces of it quickly so I will give it a couple of days in case that one guy needs the entire package in one simple purchase. After that I will have no problem parting it out. Of course you will have first dibs on the pieces you asked for =)
 

mec03svt

SomethingVeryTechnical
Established Member
Joined
Sep 30, 2009
Messages
768
Location
Glen Mills, PA
lol no rush man. It is much easier to sell as a whole for sure. PM me if it moves or you decide to part down the road. Good luck on your sale.
 

swbhobie16

New Member
Established Member
Joined
Jan 15, 2009
Messages
31
Location
wilson, nc
i know its not that big of deal, but is the belt itself included in the deal as well? been putting off getting these for quite a while and now may be the right time

edit: read it again and saw the belt at the bottom.

ill be getting back with you
 
Last edited:

layzie

Active Member
Established Member
Joined
Nov 29, 2009
Messages
255
Location
USA
What are the other pulleys for? I just bought my 04 3 days ago. I know I want the 2.76


Tony,

where-they-go.jpg


The 100 Idler at the top is to put tension on the belt to prevent belt slip.

The other three below that are just to replace the old stockers that have been known to break under high boost. They are just for protection and show.
 

layzie

Active Member
Established Member
Joined
Nov 29, 2009
Messages
255
Location
USA
FYI. I have a potential seller interested in the entire package.

SWBHOBIE - The belt is included.
 

layzie

Active Member
Established Member
Joined
Nov 29, 2009
Messages
255
Location
USA
The entire set as a whole has been sold.

Thank you for looking and most importantly, Thank you SVTP!


Ps, In a few days I may post my POSI ported EATON, TB and Plenum setup.

It is the original blower that came on my car and my car just broke 10,000 miles so it is in flawless condition. Since the POSI port it has seen less than 1,000 miles. Never abused, no Nitrous or tack runs if anybody cares.

Thanks,
Layzie
 

Users who are viewing this thread



Top