Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Engine/Tuning
Ballpark figure for rebuild and from whom ???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="03' White Snake" data-source="post: 16547210" data-attributes="member: 51916"><p>Definitely give L&M a call and go over your goals.</p><p></p><p>A factory Kellogg crank is a stout piece, the stock rods are great too. Good for ~1000rwhp. A good machine shop will clean, magnaflux the crank, block, and rods to check for cracks ect. They will reuse these if the parts are good.</p><p></p><p>I run hard coat anodized and moly skirt Diamond pistons, stock rods, a new Kellog crank, calico coated bearings, and all ARP 2000 bolts throughout the motor. I had custom cams spec'd by BulletRacingCams, I did not want super aggressive, but you can hear it chop and tell it has cams in it. The exhaust also plays a part in this. I run chambered bassani exhaust on my car. Bullit style mufflers definitely help with the chop.</p><p></p><p>My CR is calculated out around 10.3:1. I run E85 all the time in my car. On 22 psi through my 2.8h KB, my car made 823hp/767tq. My stock motor, same boost was making 694hp/672tq. So CR and cams made about 130 rwhp on my car.</p></blockquote><p></p>
[QUOTE="03' White Snake, post: 16547210, member: 51916"] Definitely give L&M a call and go over your goals. A factory Kellogg crank is a stout piece, the stock rods are great too. Good for ~1000rwhp. A good machine shop will clean, magnaflux the crank, block, and rods to check for cracks ect. They will reuse these if the parts are good. I run hard coat anodized and moly skirt Diamond pistons, stock rods, a new Kellog crank, calico coated bearings, and all ARP 2000 bolts throughout the motor. I had custom cams spec'd by BulletRacingCams, I did not want super aggressive, but you can hear it chop and tell it has cams in it. The exhaust also plays a part in this. I run chambered bassani exhaust on my car. Bullit style mufflers definitely help with the chop. My CR is calculated out around 10.3:1. I run E85 all the time in my car. On 22 psi through my 2.8h KB, my car made 823hp/767tq. My stock motor, same boost was making 694hp/672tq. So CR and cams made about 130 rwhp on my car. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Engine/Tuning
Ballpark figure for rebuild and from whom ???
Top