Alignment

xXAzureMach1Xx

Active Member
Established Member
Joined
Mar 23, 2008
Messages
1,322
Location
Pensacola FL
Anyone do there own? I know how to go about the toe and camber but not sure on the caster. From what ive read you turn the wheel 20* left and right and you setup the caster from there. How would be the easiet way to figure out what 20* is? Camber should be .75 and toe is 1/16 out. That sound right? I plan to buy this gauge http://www.summitracing.com/parts/lng-78260/overview/
 

flyby763

Member
Established Member
Joined
Jun 6, 2008
Messages
669
Location
Jacksonville, FL
I think the directions for that say that the angles on the base of the tool are about what you need so if you align that with the fenders youre good.
 

xXAzureMach1Xx

Active Member
Established Member
Joined
Mar 23, 2008
Messages
1,322
Location
Pensacola FL
Yea I read that to. Guess I could always just draw some lines on the ground and go by them. Body isnt really square so be hard to find a straight line that's straight with the wheel I would think.
 

Users who are viewing this thread



Top