I have a McLeod RST clutch that I am going to have installed soon and I am getting ready to order a flywheel, throw-out bearing and stainless steel clutch line. Any other parts I need or you guys would recommend throwing on while I am at it? Thanks!
Accessory parts for clutch replacement
- Thread starter White&BlackCoyote
- Start date
Pilot bearing, the gaskets between the exhaust manifolds and catcons, maybe an MGW shifter, poly insert for the trans mount, change trans fluid while it is out.
Not sure you want to stiffen up the transmission mount very much without also installing stiffer engine mounts. If you don't, too much of the engine torque reaction could be carried through the transmission case and its mounting (because the load splits up according to the relative stiffnesses).
Norm
Norm
I would also replace the crankshaft sensor its a pain to change out when the trans is in.
ARP Flywheel bolts isn't a bad idea.
Users who are viewing this thread
