Help!! I Have a 93 f150 with 300 6cyl. 5 Speed. Going to make a tribute Truck but it will be decaled as as a Thunder Bolt. I have a 427 Stoker 205 afr heads big hr 304/598 cam, TFS Track heat intake. w/forged internals, A Brand new T56 for a 04 Cobra with McLeod small Block Bell Housing. (My Question is About the hydraulic Clutch) I know I will need a Slave Cylinder. The Bell housing will accept a Fork for the Throw out bearing. Dont know if a slave cylinder internal will work with this setup? I put anew clutch master Cylinder on the truck already with the 6 banger. Any one ever done this swap before???? Any Comments Would be appreciated.
I haven't seen it on an F-150 of this generation. but the guys who do t56 swaps on the lightnings tend to use the viper hydraulics.
Also you need a bell housing for a 5.0/5.8. The 4.6 house is slightly different. As stated above with the viper hydrailics