2011-2013 Mustang GT/BOSS Cooling Head Mod by MMR, eliminate the #8 cylinder failure

[wikdlx]

I just installed my long tubes and did this kit at the same time, I also have this kit on my 2003 Mach1

 

[Sir Nate 3000]

Is this cooling problem on the 2015 Mustangs also?

 

[101blur]

Do you make this kit with braided lines and AN fittings..?

 

[tek302]

So you drain the coolant and knock out the two freeze plugs then bolt these in place. Refill coolant and done?

 

[Modular Racing]

Yes, a little easier said than done, but certainly anyone with basic mechanical skills can handle this install.

 

[Modular Racing]

Do you make this kit with braided lines and AN fittings..?

We do not, the barbs are built into the fittings.

 

[Modular Racing]

ttt

 

[gsxr1300]

I am having MMR oil pump, crank gear and balancer installed shortly on my Whippled 2015, this would be a good time to install this mod also. Is this still an issue on the 2015's ?

 

[Modular Racing]

Unfortunately yes, the 2015 design is even worse!

 

[gsxr1300]

Do you have anything you show about this on the 15'S

 

[Modular Racing]

 

[gsxr1300]

Sorry I meant the head cooling mod on the 2015's.
The Whipple will have to come off but with the intercooler have to come off also to install the cooling mod?

 

[Modular Racing]

No, it can be left in place

 

[Modular Racing]

ttt

 

[Modular Racing]

ttt

 

[Myusername]

Is there any other way other than removing the intake manifold to do it? Or that is the only way?

 

[SVOGT302]

Are there actual instructions we can review?

 

[Modular Racing]

Many different way, it can also be done while doing a clutch swap, from the top however, removing the manifold helps alot, certainly not a requirement but give you ALOT more room to work with.

 

[Modular Racing]

Ttt

 

[Nyke]

I bought this yesterday, forgot to mention svtperformance for the free shipping. but doing a clutch swap so this seemed like a no brainer to tackle while I have hte transmission out.