Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
04 6r80 swap cobra
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Ryan2KRedL" data-source="post: 16164387" data-attributes="member: 346"><p>On my 98 model using 3.55 rear gears, I tapped my Vehicle Speed Sensor wire (back left of transmission) harness - Gry/Blk wire, and attached it to the US Shift harness Pin 12 - Tan wire.</p><p>I had to solder in the supplied 10uF capacitor in line of the tan wire. Without this, I didn't get any signal.</p><p>Open up the US Shift software and select the Speed Sensor & Gearing tab. </p><p>Put your gear ratio and tire diameter size in here.</p><p>Next select the Speedometer Output tab.</p><p>In the drop-down box select the Ratio-Corrected Speedometer Output.</p><p>In the Speedometer Pulse Ratio box, this is where you will put in a number specific to what your car needs.</p><p>Default is 0.250. My car uses 0.080 and my speedometer reads accurately based on my phone GPS.</p><p></p><p>Good luck!</p><p>Ryan</p></blockquote><p></p>
[QUOTE="Ryan2KRedL, post: 16164387, member: 346"] On my 98 model using 3.55 rear gears, I tapped my Vehicle Speed Sensor wire (back left of transmission) harness - Gry/Blk wire, and attached it to the US Shift harness Pin 12 - Tan wire. I had to solder in the supplied 10uF capacitor in line of the tan wire. Without this, I didn't get any signal. Open up the US Shift software and select the Speed Sensor & Gearing tab. Put your gear ratio and tire diameter size in here. Next select the Speedometer Output tab. In the drop-down box select the Ratio-Corrected Speedometer Output. In the Speedometer Pulse Ratio box, this is where you will put in a number specific to what your car needs. Default is 0.250. My car uses 0.080 and my speedometer reads accurately based on my phone GPS. Good luck! Ryan [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
04 6r80 swap cobra
Top