Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
New Edge Cobras
01 Seats Converting to 03/04 Foam and Covers questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Blkkbgt" data-source="post: 16873002" data-attributes="member: 117234"><p>[USER=64234]@rzimmerl[/USER] </p><p></p><p>I can confirm all the seat frames are the same. I did this exact conversion a while back in my GT. Everything fits fine. </p><p></p><p>My best advice to you is go SLOW so you don't **** up like I did. The hole for my lumbar support button is off because I was rushing to get done. </p><p></p><p>Plan on two days and make sure you heat up your covers either in the sun or in the house. It makes a HUGE difference when sliding them on and getting the bolsters into the covers on the seat base. </p><p></p><p>Don't actually cut any holes until you get the covers in position properly and secured. </p><p></p><p>I know this sounds stupid but you may want to consider ditching the power drivers seat base. </p><p></p><p>The control switch panel for the seat requires you to cut a large hole in the foam. Doing this causes the drivers seat the not feal as firm because it now lacks support near the middle front. This is also due to the foam having less density than the OEM ford foam. </p><p></p><p>If I would have known this I would have grabbed a manual seat base from the junk yard. </p><p></p><p>If you have any questions feel free to ask. </p><p></p><p>Good luck.</p></blockquote><p></p>
[QUOTE="Blkkbgt, post: 16873002, member: 117234"] [USER=64234]@rzimmerl[/USER] I can confirm all the seat frames are the same. I did this exact conversion a while back in my GT. Everything fits fine. My best advice to you is go SLOW so you don't **** up like I did. The hole for my lumbar support button is off because I was rushing to get done. Plan on two days and make sure you heat up your covers either in the sun or in the house. It makes a HUGE difference when sliding them on and getting the bolsters into the covers on the seat base. Don't actually cut any holes until you get the covers in position properly and secured. I know this sounds stupid but you may want to consider ditching the power drivers seat base. The control switch panel for the seat requires you to cut a large hole in the foam. Doing this causes the drivers seat the not feal as firm because it now lacks support near the middle front. This is also due to the foam having less density than the OEM ford foam. If I would have known this I would have grabbed a manual seat base from the junk yard. If you have any questions feel free to ask. Good luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
New Edge Cobras
01 Seats Converting to 03/04 Foam and Covers questions
Top