thanks. when i set the timing, i rotated the engine 15 times to make sure there has no valve piston contact. Funny thing i that it did not start this issue untill 100 miles after first start. I checked all my logs from the first one.
how can i determine if its a vacuum leak? I installed the...
ok thanks.
on another issue.
On cold start if fires immediately, after reving the engine and gets to idle it will struggle to stay ideling, not every time but 3 out of 5 times. Then on a warm engine start it struggles to start.
what is the easiest way to drain the tank? its 3/4 full.
I am getting this code
Could it be related? Also what should i change first to remedy this code. Also the fuel tank grommet is torn and leaking. I read that this can affect the EVAP system as well. I am changing the grommet next
P0443 - EVAP Control System Canister Purge Valve Circuit...
ok, so after looking at the log, the fuel trim evens out under load. the separation starts as the motor RPMs fall.
At 3098 RPM the fuel trim is 1 to 1
At 803 RPMs the fuel trim is 1 to 1.19
also the car runs awesome by the way.
I checked compression on all cylinders 155-160
COPs seem to be...
I have custom blower cams for my KB build. I was disappointed by the lack of lope. I was ready to cry (yea sounds gay) I wanted the car to shake rattle and roll.
with out them, the pins just slid in. With the rubber inserts I had to push down hard on the caliper to get the pin in. Takes any movement out the caliper. Hence no rattle
I am always asking for help so I figured I would pass on some good info. I had the brake rattle for a year now. I checked everything many times, but still had the rattle. I changed the pins and clips but it still rattled. I found a kit on amazon that came with the rubber inserts for the...
oh man. that is terrible. My tuner just asked me to log my first 3rd gear full pull. I built my motor and I am nervous as all getup. did you do the build?
idea, how about repairing the the damaged area with a filler/bondo smoothing area out and then vinyl wrapping. I work for 3M and their vinyl is amazing.