Search results

I think i have a spare harness sitting around somewhere that i don't need. Ended up finding a complete engine with harness for my swap so I'll go dig it out.

I am also glad that I'm not the only one with a few loose screws doing this :D POR15's Marine Clean/Cleaner Degreaser. Smells up the garage but works pretty damn good.

Started scrubbing 27+ years of grime off the under body: Underchassis_20211121_203435 by SVT544, on Flickr

Looks good!

Pulled the old engine 20211112_195305 by SVT544, on Flickr 20211114_145642 by SVT544, on Flickr

Im in the same boat. I like the idea of a one piece headlight however from everything I have seen thus far, the fit and finish looks like $h!t.

I shop with Lethal!

Here is the one I was looking at awhile back for my terminator swap, looks a little better than your run of the mill home depot oil separator...

PM Sent

Sweet!

car-part.com can help with sourcing parts from the bone yard if you go that route. I use it quite a bit along with the sites @Tillerman77 mentioned

I also have an oil pan that I no longer need

Well crap, not sure I want to post up after that beauty but here is mine: 20210925_104102 by SVT544, on Flickr Getting ready to start gutting the car for the 04 conversion

I also have a pulley bridge that I am no longer in need of. Plane jane factory finish.

Looks great!

I am thinking about sourcing one for my car at some point...do you have a pic or two you could throw up?

I would be in for a K-member if the group buy is still moving forward

Love the build! Subscribing...

It's dat ass. It gets everyone with the tail light and bumper swap lol Sent from my SM-G950U using Tapatalk

She's a 94 with the 3.35 first T5 so I didn't want to completely lose first gear. I figured the 3.73s should be a good compromise between highway and city...I'll report back with my findings from the butt dyno Sent from my SM-G950U using Tapatalk

Dunno yet... I'll let you know once I get off my ass and finish getting the rear end set up [emoji23] Sent from my SM-G950U using Tapatalk

Dropped the factory rear out so I can swap in the replacement I rebuilt with carbon fiber clutches and 3.73s Sent from my SM-G950U using Tapatalk

The only item I saved from the SN95 tracks were the guides that the brackets are attached to, everything else was completely disassembled and discarded. For the plug I just popped the pins out and recrimped the terminals onto the S197 wiring but you can just clip and solder as needed (I have a...

Pics of the Passenger Side Manual Slider:

Pics of the Driver Side Power Seat: