Accufab tb and plenum SOLD
Diablo tuner $120
03 Cobra mass airflow sensor
Diablo mafia puck SOLD
Stewart water pump it was installed and removed $100
https://photos.app.goo.gl/w3DoqdaTgrmh9ote2
03 cobra with 118k miles, about 2k miles on built motor. Asking $20k.
Motor:
Teksid block
Brand new MMR crank from the cammer 5.0
Original Manley rods with flat top Manley pistons with valve reliefs.
Clevite h-series coated bearings
Melling oil pump
ARP main and head studs. ARP crank and cam...
Hello everyone its been a while since I've been on the forums. I've been busy with life not much time to give attention to the cobra (got married).
Well a few months ago a few buddies and I were planning on going to the track. Took her out to do some test runs to make sure everything was...
Hello everyone, I need a bit larger upper than the 2.76 I have now to go with my #4 lower. I already have the interchange ring just need a pulley. Thank
I have a Lincoln fan and a Volvo controller that makes install a breeze. I installed one on my 4x4 rig and had this extra one laying around.
150 shipped.
I'm planning on getting a 2.9 crusher really soon. Currently I'm running 60's, twin ford gt pumps on a fore hat. Will that be enough fuel for around 18-20lbs of boost. I've read that it is but looking for advise from people running the 2.9. Thanks.
So I finally got a round to doing a compression test. Built the motor last year using 18cc manley pistons, teksid block, felpro mls gaskets. All cylinders were right at 150psi. Is this normal for the lower compression pistons, thinking 8.1:1. Planning on going with a whipple 2.9 crusher...
I have a complete lower pulley kit for sale. Comes complete with a #4 pulley along with an alt pulley for the #4 lower. Also a belt for the #4 lower alt pulley and a 2.76 upper. $350 shipped.
#6 lower pulley $70 shipped.
well its been about 8 months since i started this build and after all the headaches its finally ready for the dyno. Im heading over to TPS in the morning to see how she does.
here are the mods
teksid block
ported eaton stage iv
accufab tb
2.76 upper #4lower
80lbs injectors
sct ba3000...
I purchased this new back in January during my engine build. Now that im ready to go dyno tune the car, my tuner is suggesting I go with a sct ba3000. This is new never installed.
$200 shipped.