Search results

  1. B

    FOR SALE: Tig Vision trunk mount ice tank plus a few other things

    It is a really nice tank. Just decided to go more stock route on my swap.
  2. B

    FOR SALE: Tig Vision trunk mount ice tank plus a few other things

    Tig Vision 7 gallon trunk mount ice tank with rule 2000 pump with their powder coat (brand new) sold VMP 100mm slot style maf tube (new)$80 03/04 coolant cross over has a some dents previous owner made $120 snub idler with various pulleys no bolts (used) $130 A/C delete bracket and pulley...
  3. B

    Help with injectors

    I don’t think I’ll make that much so I’ll stick with the 80’s for now. Don’t plan on going for more later. This is just a fun street car.
  4. B

    Help with injectors

    They are real deka’s. Also had the flowed by Eric Derr. Same with the last set I had. I can turn the base psi up if I need to to make the 80s work but I think it’s going to be close on duty cycle. Also not sure about what the deka’s can take psi wise before they start having issues.
  5. B

    Help with injectors

    Same gear, same driver, I had put in the injector data straight from ID. Got everything dialed back in on the tune. I had the same timing in it as before. Not sure what caused it but it wasn’t normal. Thought I’d see if others had that same experience.
  6. B

    Help with injectors

    I’m trying to decide what injectors to run. I have Siemens deka 80s but I’m not sure they will be enough. Plan on being in the 7-750 whp on e85 through a 4r70. I had id1050x’s on another build and didn’t like how much more fuel they seemed to use over the deka’s just cruising. Example the 1/8th...
  7. B

    Putting injector data in SCT PRP

    Could you explain a little more on the high slope? Wouldn’t I set that to what they have in their data?
  8. B

    Putting injector data in SCT PRP

    Should that have been 3 decimals over to make it 1.15 in the multiplier table?
  9. B

    Putting injector data in SCT PRP

    What is are people putting in the injector comp bait volt section for the FIC 1000cc injectors. Most of the injector data has it in (sec) and the prp has it as a multiplier. For example the FIC 1000 has the value at 14 volts listed as .00115. Do you just move the decimal over 2 to the right?
  10. B

    WTB: VMP TVS 2.3 blower.

    Found. Mods can delete. Thanks
  11. B

    WTB: VMP TVS 2.3 blower.

    Looking for a used tvs blower.
  12. B

    WTB:03/04 coolant cross over, timing cover

    Looking for those and a balancer. Also if anyone has a Metco lower with 2lb ring that would be great. Thanks
  13. B

    Fs fore fuel rails

    Still available?
  14. B

    Eaton swap kit

    What small items are missing?
  15. B

    F/S built alluminum shortblock

    I have a WAP alluminum block with a Kellogg stroker crank (5.0) Manley forged rods and pistons with a .020" over bore. It has clevite bearings and total seal rings. Arp rod bolts,arp side bolts and mmr main cap bolts. The pistons are a -18cc dish. This shortblock has zero miles on it. It's still...

Top