Search results

It includes complete block assembly, engine computer, engine harness, intake, s/c with 3.10” pulley, lower pulley and idlers, Accufab throttle body, custom in-fender CAI, BBK LT headers, catted X-pipe (& Steeda catback if you want it), intercooler/pump/reservoir, alternator, p/s pump, starter...

Ran this exhaust until I put on the race suspension. The tips are very discolored and can be replaced. H-pipe/cats/mufflers show use but are in good functional shape. $150 OBO and you pay for shipping. I am in No. VA will deliver locally.

This is the original exhaust from my '04 Cobra. I pulled it off after one year and it has been stored in the attic ever since. The chrome tips are in great shape. $150 and you pay for shipping. I live in Northern VA and will deliver locally.

OEM chrome wheels from my 2004 Cobra. The front faces are in good shape. Two of the plastic centers have a crack. The backsides are dirty and the paint is peeling on one. The tires are BF Goodrich G-Force Comp-2 A/S with plenty of tread. Will deliver in No VA and the Rt-340/I-270 area of MD...

Spare tire with jack out of my 2004 Cobra. $100 + shipping. Will deliver in No VA and parts of Maryland.

PA Performance 170A 6G Alternator (2606HO). Used one week while troubleshooting an electrical problem; sat in box ever since. Retail is $380, asking $175. PA Perf recommends using their Power Wire Kit (4 gauge wire with a 200A fuse).

What air/fuel ratio are you running on track (road course)? My Terminator motor is stock except for Bassani catted X-pipe and cold air intake; 440 rwhp/415 ft/lb. My last track tune included conservative ignition advance in the higher RPMs and a rich air/fuel of about 12 in an effort to keep...

Has anyone installed a switch to disable/enable the airbags?

Does anyone have a picture of an Autopower (race) roll bar in a 2003-2004 Term coupe? IO-port has some photos of the bar in a vert, but I want to see how it fits in a coupe. I know there was a thread on roll bars about a year ago, but what is the feeling regarding a bolt-in? Do they punch...

My limited slip differential is not so limited anymore. Shortly after I started tracking with slicks, I noticed that my inside rear tire would spin on corner exit. Over the past two years, this has gotten worse and the carbon fiber clutch disks in the diff are probably just carbon now. On...

What gears do Cobra drivers use for VIR and Summit Point? I have stock 3.55s in my 04 Cobra and I am red lining in 4th on both tracks. 5th gear is a little too much and I don't gain much by shifting it into 5th for 3 seconds. Anyone using 3.73s?

I take my 04 Cobra to Summit Point and VIR several times a year. During the summer months the engine temp is 105-118 deg C. Normal street operating temp is 88 deg C. Is there any benefit/disadvantage of running a heavier oil, i.e. 20W50 vs. 10W30? My thought was 20W is okay for summer...

I have been tightening up the IRS and getting more camber dialed in, but with stock springs I still get a lot of body roll. I drive the car 7K-9K miles a year and lowered springs would pose a problem. Has anyone tried using spring rubbers to increase the spring rate when going on track? It...

What is the minimum clearance that I should be running between the caliper and the spoke and wheel itself? I'm running Brembo 4-piston calipers on my 2004 Terminator. I just bought a set of inexpensive wheels to use with slicks for HPDE track time and they have 1/8th of an inch. This is quite...

Has anyone put tow hooks on their '03-'04 Cobra? I am trying to figure out how to do it with minimial "alterations". The front end is so full of radiators/heat exchangers that I may have to opt for a strap. Any suggestions?

I do 3-4 OT/HPDE weekends a year and it is getting to the point that I think some extra protection might be wise. If I was full-out racing, there would be no doubt that I would have a 6 point cage welded in. But because I use the car on the street and sometimes have a pair of young kids in the...

I need a rear seat (bottom portion) and seat belt receivers for my 2004 Cobra SVT Coupe. Leather/suede; black/gray. I live in Northern VA and would prefer to pick it up vs. ship it.