They are from an engine that lost a tensioner and trashed the guides, I bought it for the block. Bearings are shot but no observable damage otherwise. 50 in my pocket
Listing here because of the 6 bolt flywheel. Only 2000 miles on combo. Was installed on a 2006 gt but taken back when it didn't fix 3rd gear grind on tr-3650. Was swapped for a t56 magnum. Will fit the Wap aluminum block 05-09 gt's as well as romeo new edges. Won't fit windsor or 4 valve...
Sold
Brand new. Will fit a ram with dual exhaust and newer f150 if your converting to dual. 304 stainless will never rust. Great Borla sound and no drone.
120 shipped
Both in good shape. Rod ends tight, no play. Rod/panhard bar can be shortened and tapped to work in 1998 and prior cars as per my conversation with mm tech.
225 shipped for Borgeson steering shaft--->SOLD
250+ split shipping for panhard bar
I'm needing a beefier clutch for the future power plans on my car. At the time I have a mach 500 Exedy(26spline, 11") which has great streetability and low peddle effort, has under 2000 miles. Its rated for 510 ft-lbs. Would trade the clutch and flywheel(8 bolt from mach 1) for a mach 600 Exedy...
i have a 2.5" violator catback on my 01 bullitt. looking to trade for a xr-1, dynomax ultra ect. looking to stay away from magna packs, might consider the normal bullets. would trade just mufflers or catback if shipping was reasonable.
mufflers are 2.5" 409 stainless, offset/offset...
looking for a nice fresh wap block for my build that doesn't need more than a light bore or hone. i will be boring out .020 but would prefer it not to have scored cylinders and not need any other machining.
i am located in se michigan and am willing to pick up/meet if close enough.
let me...
looking for a nice fresh wap block for my build that doesn't need more than a light bore or hone. i will be boring out .020 but would prefer it not to have scored cylinders and not need any other machining.
i am located in se michigan and am willing to pick up/meet if close enough.
let me...
i need a .020 over block preferably wap but teksid is fine too. would prefer it to already be machined and ready to go but will take one that needs some work.
let me know what you have!