Search results

2001 Cobra "MAKE ME AN OFFER" Red 45,000 miles this car ran a 11.7 at 122 mph spinning bad out of the hole and when i hit 2nd gear more spinning on 18" cobra r's. this car can go into the 10's w/slicks upgrades: solid axle w/410's, 33 spline axles, auburn locker, eibach...

Original Y2K Cobra R's with brand new tires. Nittos out back and Kumho in the front. Tires are 275/40/ZR18. $1000....local pickup preferred unless buyer is willing to pay for shipping. pics are avialable!!!

I am thinking of selling my cobra. You can see my mods in my sig as well as the times it runs. I looking to get 23,000. i have about 30,000 in it. pm for pics, 45,000 miles and it also has chrome 18" cobra r's on it.

well i just installed my longtubes, coilovers, tubular a-arms, tubular k-member and 90/10 drag struts. I went to the track thursday night and when I hit 3rd gear my car was like it was on ice. I have no idea how i didn't hit the wall, but somehow i didn't. I went out again and was slipping and...

how many of you guys are running without your front swaybar?

i can only heat my bottle up to 900. will it help me to heat it up to 950 or 1000 and will I see a difference?

i went to the track saturday night to see what my car would do with longtubes, k-member, coil-overs, a-arms, and lakewood 90/10s. it rained a little bit before i ran and i didn't hook to good but times were ok. my 60' ft was bad. you can see in my sig where you 60' was. tell me what you think...

well my tubular k-member, a-arms, coil overs, and long tubes are installed. now I have a metal to metal beating noise at the drivers side front. Don't have a clue what it is. I have checked everything. any idea's? It only happens when I hit a bump. Sounds like it is coming from where the strut...

for those of you that have added a tubular k-member and tubular a-arms did you notice any change in your et or mph?

i was wondering will my stock struts work with a granatelli coil over kit?

can you guys tell me how much hp and tq you gained after you installed longtubes?

will i need new bushings when I install my tubular arms to my new k-member or can I use my old bushings?

where can i hook up the chains to jack up my 01 cobra motor with my motor jack.

will i have to relocate my oil filter when i install my granatelli k-member?

can anyone tell me how to post pictures on here?

everyone keeps telling me that car is either a freak of nature or it has motor work to run the times I do. I have not done any motor work to it, but whoever owned the car before me could have. My times and mods are in the sig. Tell me what you think.

i have 4:10's in right now but I am going into 4th gear right at the 1/8 line. will changing to 4:30 make a difference in my 1/4 mile time or am I better off leaving the 4:10s in?

I see some of you guys putting seafoam in your cars. What is that and where do you get if from?

have any of you guys ever put the restore in your oil?

Looking to buy a set of 03-04 heads also looking for some forged pistons

Will a bad pcv valve cause your car to smoke? Also can someone tell me what a bad guide is?

my car smokes out of the tailpipes only when I "let off" the gas. It does not do it under normal driving only when I get on it hard. I does not smoke while I am running down the track, only at the end when I let out of it. It never smokes when I am at idle either. My tuner told me I probably put...

I know the old NOS kits came with a fuel pressure saftey switch, which people keep telling me to get. According to Zex the control box reads nitrous pressure and adds or subtracts fuel to keep the car from running lean or rich. Would i benefit from a fuel pressure safety switch with my Zex Kit?

do you guys think that a 125 shot with the proper tune will hurt a 01 motor?

what are the signs of a broken motor mount?