If you are getting a clunk when you go into first, it is not the diff, its your clutch not disengaging fully or you shifting into gear before the input shaft stops spinning which then makes a clunk at the rear. Try going to 2nd or 3rd first then go to 1st, clunk won't happen once input shaft stops.
Update: through many uses of the test light, multimeter, and studying wiring schematics, I found the issue. This little fuse link is shot..the EEC was getting power but no trigger for the relay, coil, or injectors..all relays tested and working, TFI module good.
Need a little help…Car will not start. No fuel pump prime, no power to the coil, no power to fuel injectors. Turn the key, all dash lights come one, try to start and she just turns over and over, not any type of fire. It just died while driving down the street and hasn’t started since...
Replaced the solenoid pack with one from Ford, it did not fix the problem..didnt even drive it.. it started while the truck was idling. I cleared codes and it all came back..I am at a loss..
Well, couldn't change the solenoids..the ones ordered were not the correct ones, also the solenoids are part of a solenoid block, not individual like I see in some pictures, l dont see a way to change them without replacing the entire block.
Thanks, got solenoids on order..I will be dropping the pan this week. I have a multimeter, but what am I looking for? I cant get to any wires up on the trans.
Looking for some knowledge..My 04 Lightning has the dreaded O/D light flashing, just started friday after putting in new cruise control switches, the check engine light came on after, pull code and it was P1746. I have checked all wiring around the engine and transmission, nothing is touching or...
If the state (where purchased)required front plates, dealer drill holes unless buyer catches it before they do it. If the state didn't require, dealer mostly wouldn't drill the holes.
PistolWhip, thanks for the help.i ordered the OBD connector and downloaded the software. I went to the motocraft site and can't figure out how to download the as built data for my mustang. Any directions?
How do I get the FORSCAN software and tool to connect to the OBD? Is there a subscription? I would like to try it. I read somewhere that (cant remember forum) a guy just changed a 0 to a 1 (I may have the wrong numbers, but you get the idea) and it changed his screen from the horse to the...