Search results

Can anyone recommend a good shop to install a new shortblock in my 04 cobra? I'm in Louisiana but willing to travel. I can't find a performance shop locally that will do it.

Just go my car back to together after it's been sitting up for a while. current setup: 3.4 whipple with crusher intake return style fuel system, ID 1000's, external fuel pump, custom tank, yada yada yada Stock motor. Data log short term fuel trims stick at .75 and 1.25 respectively...

I have a LFP black powdercoated intercooler tank for sale. Has less than 1500 miles on it since installed. Here are a couple of pics of it on the car. Has slight surface rust on the inside of the ring where the fill cap goes but this is pretty normal. Still seals perfectly with no leaks...

I'm going return style on my fuel system and was wondering what some of you guys did for your system. I'll be using a glenn's sleeper sumped tank, Aeromotive Eliminator pump with the fore rails and regulator. Thinking of doing 10an feed split to 8an to the rails and 8an return. What is the...

Accufab throttle body for 03/04 cobra. $275 shipped. Post up your email address if you want pics.

60lb Inj/2400 SCT MAF/JLT CAI Hi Boost JLT High Boost Intake SOLD SCT 2400 MAF SOLD 10 spline input shaft $85 shipped All parts have 2k miles or less on them. The JLT has the normal wear where it enters the fenderwell but what is visible under the hood is in perfect condition. I also...

Anyone running this combo? What kind of numbers/track times with this combo? Thinking of going from a 3.2 to a 3.0 lower. This is on a 1st gen whipple also. I am currently making 19lbs of boost in the dead heat and have seen as high as 21 - 21.5 in the cold.

How hard is this to change without dropping the pumpkin?

I'm hosting a BBQ/Get together this Saturday the 12 at my house if anyone ones to come by. I'll have burgers, chicken and ice provided, you just need to bring what you want to drink and are welcome to bring whatever else. We are kicking it off around 5-6pm. Here are directions to the house...

Anyone going to the test n tune at state capitol raceway this Sunday? Weather is supposed to be perfect!!! Cool and dry!

Does anyone make a DOT drag tire that is 27 or 28 inches tall?

A video someone took of my car at a test-n-tune November 2008 2004 Cobra 2.3l Whipple 20lbs of boost (4lb lower/ 3.2 RR upper) Tuned by Cody of www.stanghi.com 10 spline input shaft / stock halfshafts qa1 coilovers all the way around. MM k member kit Full Interior (empty trunk)...

I'm currently running a 4.10 gear on my 04 cobra with pretty good results at the track. Fixing to get the rear cover replaced with an aftermarket piece so was thinking of changing gears out to a set of 3.73's. Car weighs about 3750 race weight and runs 133 in the quarter how it sits. Any...

Just curious what people with this setup are setting the shocks on... I have 12 way adj front at back with 225lb coilovers and running bogarts with slicks and skinnies... Runnin the rears at about 8 clicks and the fronts at one full turn from fully loose, but it likes to get a bit squirrely on...

sold

stock 03/04 cobra maf $50 shipped JLT CAI (black) complete. Wear in typical places where tube goes into the fenderwell. Been on car for about 1k miles $150 shipped JLT PCV Pre-Filter (silver) $20 shipped Diablo Tuner $125 shipped

what kind of tire pressure do you guys usually run in your slicks at the track and what RPM do you shft at. Running a whipple at 17psi...

I am running a LFP 4lb lower and 3.5 whipple upper with billetflow idlers. Should i be having charging problems with this setup? Should i get a bigger Alternator pulley?

Steeda GT500 Cold Air Kit - 2007. The kit is supplied with a stainless steel air box with built-in Billet aluminum Super Velocity stack. It mounts in the factory location with the supplied rubber trim to keep the hot air out. Billet mass air meter is bright nickel plated for a lustrous...

Does anyone sell a stripe kit for the 03/04 cobras?

Has anyone install these on an IRS car yet? Got a set in yesterday and they don't have instructions for IRS cars. It has upper and lower brackets, but I just don't see anyway that the lower brackets can be used. Anyone installed a set of these yet?

Took some pics this weekend of the turd with the new wheels i bought on here from JP. Thanks to 1CRZHRS for taking the awesome pics! Some group pics of everyone that was with us that night...

Will be taking these off of my car in a couple of weeks.... Both have probably less than 4k miles on them. UPR Offroad X-pipe 99-04 cobra/gt $100.00 Magnaflow SS catback for 99-04 cars with IRS $300.00 I'm willing to meet you half way for these items or possibly even deliver depending...

Control freak IRS girdle http://www.atomicperformance.com/index.asp?PageAction=VIEWPROD&ProdID=2126 What you think?

I have three pullies for sale: Reichard Racing 3.00 pulley for Eaton Supercharger $80 shipped Reichard Racing 3.0 pulley for Whipple Supercharger $80 shippedSOLD Reichard RAcing 2.8 pulley for Whipple Supercharger $80 shipped SOLD