I have a good size gas leak where the filler pipe inserts into the gas tank. It looks like there is a rubber grommet thing that the pipe goes through to get into the tank but it is pretty torn up. I checked the parts list online and i don't see anything I could get to replace it. Any ideas?
Hi Guys,
I have a 97 cobra. Just finished a rebuild and fired it up. Ran well but there was a rattle noise coming from the front of the engine. I opened it up and did not see any damage. I did notice that the drivers side primary chain was a bit slack on the non-tensioner side of the run...
The car is on jack stands. I start the car and I hear a rubbing. I have disconnected the clutch cable and put the car in neutral.
When I press the brake pedal I hear a loud rubbing noise and get severe vibration through the pedal. The only thing I could think is that maybe the ABS is going...
Hi guys,
I know this is not terribly scientific but I was unable to find a cam card on either the 97 or 03 so I just looked at them. They both appear to have the same lift but the 97 has much greater duration on both the Exhaust and Intake cams.
I don't know how this will translate to HP...
I mangled it a bit taking ti out on an engine rebuild. I didn't realize how bad it was till I tried to reinstall it. Any idea if there is an aftermarket replacement for it? it is a 97 cobra.
Hi guys - I am putting my old 97 cams in my new 04 heads and want to set the timing. I have not been able to find a cam card for either so I figured I would just set the timing so both banks match. Reading the manuals on this (have not done if before) it says I need a solid lifter so it...
I have a leak in the high pressure hose from the power steering pump - the line has been discontinued by Ford. I could put an - AN adapter in on each end and run a russel hose but am unsure of the size 16M or 14M of the hole on the power steering pump. Any ideas? Do you know if the GT's ran...
Any of you guys running a remote oil cooler? I had some bottom end damage (Shattered woodruff key) and was looking to replace mine but it is about the same price as just going with a remote cooler.
It looks like I could use the 97 GT oil filter block adapter and put a sandwich plate on...
I have a 97 Cobra and I just finished rebuilding the bottom end with a DSS girdle, ARP main bolts, CP pistons, Total Seal Rings, and Manley rods.
I was going to rebuild the heads but the guides were shot and they needed alot of work just to get them back to stock so I bought some 04 heads...
PARTS LIST - All parts in working order and in good condition
================================================
97 Cobra Intake Manifold Upper and Lower (w/out tb) $300 SOLD!
97 Cobra IMRC plates $65 SOLD!
97 Cobra IMRC Cables & computer $60
97 Cobra Stock Dual Plenum Throttle...
I am pulling my engine and need some advice for attach points for the hoist. I don't want to pull the transmission if I don't have to (and use the upper trans bolt holes and alternator holes).
I looked into getting the Rotunda lifting eyes but they are listed for $400 online and am not...