My truck and rims are in need of some new paint. Anybody know a good painter in Broward county?
A couple of the rims have a little curb rash that will need some attention but not too bad. There is some rust starting on the roof near the windshield seal and on the doors just below the window...
I have a Ruslow drive shaft loop that I need to install. It doesn't require any drilling but since it's a one piece I do have to drop the drive shaft. How do I do that? Do I just remove the 4 bolts at the rear of the ds in order to drop it just enough to pass it through the loop, or do I have to...
I didn't realize the Expy console was not symmetrical until I noticed part of the inner shell was smashing into the transmission hump trim piece. Are you guys trimming this?
Does anybody have some pics of their passenger seat after the bucket conversion but before installation? Is it a mirror image of the drivers seat? I'm just curious how the seatbelt is routed (through or around the seat).
So after I changed my oil today I noticed some "copper" granules in the catch pan. They are about the size of small to medium grains of sand. I didn't look to see if the pan was clean to begin with so I don't know if these were already there. Are there any internal parts that are copper? Main...
I noticed smoke coming from my right rear wheel after a trip to the store and an extreme amount of heat coming from it as well. After a quick inspection, I think I have a seized caliper. Is this the only thing that would cause this? Why would it seize? What else do I need to inspect? Will I need...
Look what I found when I cleaned out my closet the other day. Well what do you know.? I forgot those where in there.
As you can see, I'm a little behind on my installs. I did however get my L/T's in this weekend.
Is it worth the money to have a good set of SS headers ceramic coated just to lower under hood temps? If there is a drop in temps, is it significant enough to notice and will this help performance?
I just bought a used KB and I need the installation instructions. I will be using the stock plenum. Will someone post them or scan them and email them to me? I need the torque specs and pattern along with how to modify brackets. There is a vacuum line that needs to be capped too, right...
How much upkeep is required to keep polished interior parts looking good? I'm thinking about getting some pieces but I don't want high maintenance stuff. If it's a lot of work maybe I'll just get satin finish pieces instead.
Has anyone bought a Sir Michaels roll pan lately? Are there still fitment issues with the ones being sold now? If so, what specifically are the fitment problems?
Thanks
My AEM wideband reading fluctuates a lot between low 15's and low 16's at idle and mid 14's to high 15's at cruising speeds. At WOT it starts around mid 11's and drops to mid 10's. I know the WOT 3rd gear reading is what’s most important and that I’m running rich there, but I am concerned about...