Dark shadow grey, 60,000 miles, convertible. 4.6 supercharged 6 speed. Garage kept and stored during winters. I am the second owner.
Mods,
JLT CAI
Metco 2.80 pulley
Tune by Amazon tuning with a SCT tuner
Billetflow idler pulley's
Dynoed at DB performance MGM short throw shifter...
Installed it last night and drove it to work this morning. Finding gears is much easier and the reach to third is great:banana:. Downfall right now is, that she is mighty stiff and notchy right now. I actually think my arm is tired. I'm sure she'll losen up in time.
Going to put on my boost overlay, but I'm off to a bad start. Any ideas how to get the headlight switch knob off. I just can't seem to get it to come off.
I got my new rubber installed (315-35-17's) along with 1" spacers. And since I had the tires off i also took the time to do the wheel mod, pic doesn't do it justice. I'm fighting the sun with my camera, gonna try to get some better ones at sunset.
before,
after,
I ordered some 1" spacers from Lethal, they are on national back log with no eta for new ones. So had to cancel that order. Man I am bummed out:cryying::cryying:, just ordered new rubber and wanted the spacers to go with it. Also checked with MM and they said the same.
I noticed today that I have completely used up my tires (i won't drive it right now, she's bad). I have stk chrome rims and it is mostly DD, she'll never will see the track. So my plan is to buy Nitto NT 555 Extreme Performance 275/40-17's for the front. And for the rear is where I need help...
OK, so I plan on stripping the silver coating of the back side on my stk rims. But it appears the same coating is also applied in the lugnut holes. Can I remove that too? The coating just seems to make it look dirty..
It was my first time ever dynoing a car. Pretty cool experience. Looks like my AF can be tweaked on to help improve sum, ran rich for a while, yes there are just numbers but I like the look so far, it made my day.:dancenana:
I need to get a new belt for my set-up, K080745 is what I need, but should I get the K080745HD? Looking at the gates site, it looks like the HD might be a bit thinker due to the slightly larger o.d. circumference.
trying to install my intake, but I can't even come close to getting the heat shield installed. Does anyone see what might be wrong? And is it ok not to use the cover, pics below. :shrug:
cover sitting on filter,
Jared,
I'm looking at SLP 03-04 Cobra Supercharger Pulley Removal Tool (Model: M10003). It says it removes the pulley, but will it also install the pulley :shrug:?
Jeremy
Well, I'm working on what I am going to order to reach my goal. Asking for everyone's opinions on what I plan on doing and what I may be missing. Here's what I have in my cart so far (from Lethal),
JLT 03-04 Cobra True Ram Air Intake,
BilletFlow 03-04 Cobra Individual Non-Slip Pulley Ring...
I'm cutting my springs to lower the cobra. I just cut 3/4 coil off of the right side front spring. Put eveything back together and backed the car out of the driveway and then back in. Remeasured and it only went down by 1/4 in. Does that sound right?? I only did one side to start with to...