May consider trades plus cash or Honda CBR600 or a car, preferably something 4 cyl and manual. Will consider classic cars, preferably Ford. When you email me with a trade offer, please send pictures it does help you know. NO TRUCKS. NO HONDAS NO ACURAS. (cars)
CAR WILL PASS CA SMOG
Up for...
I have a H/C/I 5.0 that needs some tuning. I can not bring myself to give a stranger $300+ for a tune, not to mention I still need to drop another $300 on a chip. I am looking for something affordable that obviously works. Any recommendations on a certain chip/software?
Looking at some Weld drag lites. For my notch. What is our bolt pattern for our 4 lug? I want 3.5" in front and 8" in rear, what backspacing am I looking for? Can a 9" fit in rear?
Any help and pics are appreciated, thank you.
I have a 90 Coupe and just ordered a B&M pro ratchet for it, trying to get mounting ideas, however I want to see them all. Post what you got!
Not the shifter I ordered but close, found this on LS1TECH.com, clean install!
***READ*** The car on the left bank is running low on compression,dont ask because I don't remember the numbers. This is not because of the nitrous kit because I was never able to use it. No oil in coolant or vice versa. I have yet to check the coolant for carbons and it doesn't consume oil. I...
On top end or a good load. Has happened in fourth each time,I am WOT,about 4000-6400 and I am getting a heavy vibration with hardly any power to accelerate. Am a bit worried,yet to compression test but want to see if anyone has had this problem.
Soon to be rebuilding my motor. I wish to go JE Pistons and rods if they make them,if not maybe eagle. ANy suggestions on what to use? WHat brand? Flat top or dish? SHould I even bother getting rods?
Need to pull the motor soon,she is hurtin'. Any write ups out there for this car? I am used to pulling engines out of a particular trans am but its tubular K and only necessary equipment make that job easier. The Cobras look like a world of hell when thinking of pulling the motor. SO who knows...
Charcoal/Silver suede rear seats,need as well rear passenger interior panel and both (Front and rear) passenger seat belts. Please dont come as 700 for your rear seats alone because im not stupid,work me out a deal on all items and you will have cash in your pocket.
Getting to expensive for me at the moment.Car has 60,xxx Car was never tortured nor pushed too hard. Always clean and cared for and of course garaged. Never smoked in. Asking $19,900 or take over payments and maybe a little cash if your serious,if your just a tire kicker dont waste my time.. It...
Just recently I noticed (Not sure how long it has been happening...) but I see no fluid movement in the intercooler tank. Does anyone have any ideas or have experienced this? Before we go right off and say BAD PUMP!!! I want to know if there are any other quirks that could cause this...and yes I...
I was handed a referee ticket last night for (Intake and nitrous system). No matter where I search...it is a run around..no definite answers. I tried searching an online vehicle code,and that was crap. Before I ask,remember when stopped I was pulling into a parking lot (where we usually hang out...
Long story short,rear seat caught fire. I need the following items and I am Very very very tight on cash. I prefer local stuff only please...
Parts needed:
Rear upper and lower seat. (Grey insert.We can trade for black if you feel like only getting front seats in exchange.)
Rear passenger...
I am looking to get their Termi kit. I have a coupel concerns which I found no answer that helps me.
1. I have a JLT cold air...how can I mount the dry nozzle pre-maf?
2. What supporting mods are REQUIRED to ensure I do not go boom. (Only going to run 50/60 shot)
3. IF! I buy the kit,am...
This has been going on for a while now,but it is now worrying me. Sometimes during the morning or when it is cold,I start the car and I can hear the blower squeeling like bad brake pads squeeling. Not the whole time but comes and goes, it fades in and out and happens for about 2 secs each time...
Getting to expensive for me at the moment.Car has 60,xxx Car was never tortured nor pushed too hard. Always clean and cared for. Asking $22500. It is about bluebook and is what I currently owe.
Mods:
JLT CAI
Accufab single blade Throttle body.
Billetflow 2.9 and idlers w/ snub
Brothers...
Hard to explain through words but I shall do my best. I notice when cold or at low housing track speeds, the car has a hesitation to it,slight but noticeable. Also when revving the engine up to 2k and holding it you can feel/hear the miss...almost like a slight sputter. Anyone have any ideas? I...
I am soon selling my Termi. I know it blows but too much on payments plus insurance atm. For a replacement I am looking at a 94-95 5.0, OR a 01+ GT w/ 4.6 SOHC. This is where I really need pros and cons. I wish to go heads cam and/or cams with spray for now. Later on who knows. My main concern...
03 Black coupe $23,000obo
Getting too expensive atm. And cant give her the attention she deserves with new projects coming up. I still owe quite a bit,considering trades. Car has 59,xxx. Car was never tortured nor pushed too hard. Considering trades, looking for 67-68 mustang coupe hardtop,no...