Search results

2001 Stock Cobra Cat-back Exhaust - Perfect condition, all stainless, flows better than 03-04 exhaust. $100 Firm - Local pick-up only. Thanks, Bill [email protected]

1990 Mustang LX 5.0, 5 Speed Manual Transmission, Grey Cloth Interior, 51,637 Original Miles, Garage kept for the past 11 years and is in pristine condition. This car has been serviced regularly with only the best synthetic fluids, never abused and was always properly cared for. I am the...

After serious debate and some skepticism regarding my mechanical abilities I am going to attempt to install Hooker LT's on my 01. Some questions for those who have done or know about the install: 1) What special tools are needed (Engine lift, special wrenches, impact gun)? 2) Is it OK...

Looking for a new 01 upper and lower Cobra intake. Ford Parts Network and my Ford dealer quoted me $900 for both which I think is extreme. Anywhere else cheaper? I was going to Extrude Hone the intake (lower) and polish the lid while keeping my original stock. What kind of power gains can...

Does anybody have a cut-away schematic of an FR-500 muffler? I was thinking of cutting the muffler open and welding open or removing the trap door for constant straight through exhaust. Any thoughts on how this might affect below full throttle performance?

With winter storage right around the corner, can anyone recommend a quality car cover than will insulate against - rain, snow, sunlight. Also, I've seen people at shows with wheel covers also - who sells these? Also, is anybody renting garage space in the Philadelphia area? So far not to...

Looking to replace the half-shafts on my 01 with something that will handle a drag radial or DOT tire. Has anybody tried using a set of 03 COBRA axles on their 01? Does Ford sell these through the racing parts catalogue? I realize GKN makes a replacement but they seem expensive. A buddy...

Dyno Results: Last week I added the FR-500 exhaust and this past weekend I added a set of Steeda Power Pulley's to my 01 Cobra. Today I made three dyno runs at JD's Performance Center in Huntingdon Valley, PA. The #'s were very impressive. Bone stock w/ paper filter and silencer the car...

Plan on installing the exhaust system this weekend: Did anybody have any problems with the install or alignment? I believe I heard the right side runs close to the IRS dampener. Did anybody weld the system? Any feedback or tips would be great. Thx, Bill

Grp, After 11K my Cobra has suddenly started to ping, but only does it on occasion. The car has always run great and has never detonated before, which leads me to believe there is a flaw in the cylinder head. I have tried different types of fuel but have had little luck removing the...

Made a trip to ATCO last night - Results are below for my four runs. The weather was exceptional and my stock Cobra got stronger with each run and as the night went on(Colder temps, less humidity). Run 1: ET - 13.994 1/8 - 9.186 60' - 2.335 MPH - 103.80 On this run the car spun like...

Trying to gather consensus on typical 60 foot times for the 01 Cobra on the Comp TA ZR's. Friday night at ATCO (NJ) I could only muster a 2.286 and 2.368 on what appeared to be a good hooking track. I was coming out between 1500-2000 but spun really bad. Any thoughts or suggestions...