Search results

  1. MikeLTDLX

    FSOT: Single Digit Forged LS Turbo Swapped Fairmont Sedan

    I have been racing, modding and improving this car for over two years. It has been a great car and I have had a ton of fun with it. However, I have found myself not racing much lately and the car is going to waste. I just swapped in an all fresh, all new forged iron 370 and a billet Borg S484...
  2. MikeLTDLX

    FS: SCT X4 Tuner

    SCT X4 tuner. I detuned my car and no longer need this. $275 shipped.
  3. MikeLTDLX

    Complete Nitrous Outlet Hardline Plate Kit. Window, Warmer, etc.

    Nitrous Outlet Hardline Plate kit for Coyote. This is a complete kit. I have all of the jets, including a set of 125s that I bought. Top of the line Nitrous Outlet bottle warmer and pressure switch (heats the bottle incredibly fast), pressure gauge on the bottle. NOS window switch and Nitrous...
  4. MikeLTDLX

    Turbo Fairmont Goes 9.5s on Low Boost....

    Still dialing in this new forged LQ4 and BW S480 combo. Kept blowing intercooler pipes off, so this was the only clean pass. I was hoping to pour 18-20 psi to it and up the timing, but it was not happening. This was a 15 psi, give or take, run with only 12 degrees of timing. My goal is to get...
  5. MikeLTDLX

    15 inch rear drag wheel setup for cheap....

    Yep, this will fit with some grinding on the caliper with an angle grinder. I went slowly, painting the caliper after each grind session and rolling back and forth in the driveway until it stopped rubbing paint off. In the end, I did not take much off. Not as nice as a Race Star/Weld/Bogart...
  6. MikeLTDLX

    Goldmember on the launch, late for Church!

    There was a track photographer there on Sunday. Not a bad launch for the Grandmamobile, LOL.
  7. MikeLTDLX

    Took the 5.3 LSx Fairmont to the Track Today...Video Inside.

    This was my very first pass. Ran the car on wastegate alone, which is 13 psi average boost. Cut a pretty lazy 60 foot on the anti-lag and about 6-7 psi. I will have to work on that. I made one more pass on higher boost (around 17), but spun to a 2.0 and went 10.55 @ 136. I got warned before the...
  8. MikeLTDLX

    Some Turbo LSx Fairmont In-Car action with Killer Sound....

    I took an old friend for a ride today, here are the results: Spalt takes the Fairmont Challenge....5.3 Turbo LSx Fairmont Ride Along - YouTube This car is too much fun. Mike
  9. MikeLTDLX

    Turbo Fairmont In-Car Action....

    Just a short little pull in the turbo LSx Fairmont. This thing piles up speed at an alarming rate, so you really can only get into it for a few seconds at a time on the street...... 650 RWHP 5.3 LSx Turbo Fairmont Quick Blast Helmet Cam - YouTube
  10. MikeLTDLX

    NGK AFX Powerdex Wideband 02, Like New!

    This is about a month old. Was on my 408 that is now sold. The sensor itself has about 20 miles on it, and about 30 minutes of operation. Comes with all parts (bung, manual, etc.). These are known to be among the most accurate wideband setups you can buy for your car. Easy to install, you can...
  11. MikeLTDLX

    Ultimate Mac Daddy CCW Drag Setup for Coyote!!!

    Ultimate CCW Drag Setup for Coyote, Wheels and Tires $2,000. I have now owned these twice, LOL. I keep thinking that I want to race the Mustang again, but then I decide not to. Tires still have less than 10 passes on them and are in great shape. Wheels are just about perfect. CCW drag...
  12. MikeLTDLX

    Boss 302 intake installed on 3.31 car, impressions.....

    Installed it today. The install was relatively easy. It was a bitch to remove the rear clips that hold the wiring harness to the back of the intake, so they got the wire cutter. The LMR "install" kit that assists with relocating the purge line is a waste of time. I used the line and the...
  13. MikeLTDLX

    Going to install Boss intake this weekend, tips?

    If the weather permits, I am going to finally get this Boss intake on my car. Any tips from people that have done it? Any special tools needed? Thanks, Mike
  14. MikeLTDLX

    Wheels Up!

    Track photographer caught my best pass. This is a 1.42 60 foot. Not bad considering the fact that I had 6 bent valves on this run. Going back together this weekend and hoping for better runs next time out. Heads are all finished.
  15. MikeLTDLX

    My 408 Fox cracks the 10's, in-car and exterior vids.....

    After swapping on fresh head gaskets, I got the 408 Fox out to the track on Friday. DA was pretty good, around 500 feet, and I cracked the 10's with a 10.99 @ 118.4. This was on a 1.42 60 foot. The car still felt a little soft and I am still chasing this breakup at 6500 rpm. After this run, the...
  16. MikeLTDLX

    Accufab TB impressions......

    I installed an Accufab TB today, courtesy of my friend and SVT member Brandon (CajunCreeper). I have to say, I was not expecting anything from it. I figured since he was not using it and he was willing to let me borrow it...I might as well. Install took 5 minutes. Very nice looking unit as well...
  17. MikeLTDLX

    Wet kit lean spike issues and a BAP?

    Has anyone tried a BAP to overcome wet kit lean spike issues? Found a nice deal on a wet kit locally that I would like to buy. However, Shaun is concerned about lean spikes. He suggested a stand alone enrichment system, or somehow tapping directly into the hat. I don't want to spend the $$ on...
  18. MikeLTDLX

    Axle Back # 952 on the way...LOL.

    Axle Back # 952 (JBA) on the way...LOL. NOW INSTALLED. After my brief flirtation with the 2 chamber Flows, I went back to stockers. Just too quiet. So, I have been running the Pype Bombs that I got for the track for about a week. Just a bit too much for a DD. I ordered some JBA's today, since I...
  19. MikeLTDLX

    New Cobra Jet is a TWIN TURBO?!?!

    Apparently the new CJ was unveiled at SEMA, and it is a twin turbo offering. Wow, quite an escalation! Mike
  20. MikeLTDLX

    Some GoPro in car footage of racing today, new exhaust and HD sound....

    Tried to take my 408 Fox to the track today. Made it 20 miles down the highway with 4.10s, a C-4 and mid 80 degree heat and turned back and got the Coyote. To be honest, my heart was really not in it today with this car. Still, I made three passes and this was the best. Just could not hook...
  21. MikeLTDLX

    Ride along and WOT blast in new 408 coupe....

    I got this coupe this weekend. 408 stroker, C-4, Nitrous Pro-Flow kit, 4.10s. This was the second time I took it out. Still learning it, of course. You have to make that 1-2 shift pretty quick, LOL. The action gets going around the 2:40 mark.... 408 Stroker Fox Body Mustang WOT blast and...
  22. MikeLTDLX

    Who is using the MSD 2 Step?

    I have one of these, not sure if I want to use it. Does anyone have experience with it? How do you like it? How did you wire it up? Mike

Top