Hey Folks,
I bought my Cobra some years ago and was told it had some Comp Cams. I've just been curious as to which exact cams I have but have a hard time finding them only with the engraved numbers:
Y1008-12
HR118.0
9223/9323
The camshaft girdles haven't been modified so I imagine it's not an...
Looking for a used T56 out of the 03-04 SVT Cobra's. Prefer one with a 26 spline installed, good working order. I live in the Phx, AZ area but willing to travel to SoCal or neighboring states to pick up a good one.
LMK what you have and price.
I turned the car on one day and immediately noticed a loud rattle noise from the passenger's side head. I popped off the valve cover and noticed the secondary timing chain tensioner plastic guide (bottom one) was broken to pieces and there was some slack in the secondary chain. I replaced the...
Has anyone built their own terminator engine in their garage? How difficult is an engine like this to build oneself? I never built an engine myself but believe I can work my way through it.
I was thinking about building my own engine, and using local machine shops for block and head prep. The...
Recently, while driving, my AC stopped working. I tried refilling the AC and it worked for a little bit until I turned it off and then back on and no AC again.
I checked the AC clutch and it was shot, and so was the bearing on the AC pulley. I have replaced the AC coil, pulley w/ new bearing...
Any one know what size nuts (bolt size and pitch) fit the rear end tie rod?
I ran to lowes/Home Depot and they didn't have the fine pitch that fits the tie rod bolt. It's either a 5/8 or a 16, just dont know what pitch. It looks like I have the Maximum Motorsport adj tie rods? Don't want to...
I've had trouble finding an off-the-self Catless H-pipe for Kooks long tube headers. Any one have recommendations for an O/R H-Pipe?
My kooks LTH's have a 3" collector, and I have a 2.5" magnaflow catback. All the ones I've seen are catted/catless for stock exhaust manifolds, or shorty...
Got a couple questions:
-Where can I buy shims? Do the shims go inside the bearing cup (against the TOB sleeve) or on the rim of the bearing cup against the case (where existing race is)?
Second, the input shaft tapered bearing has a lot of play compared to the counter shaft bearing.
-Is it...
I am have grounding issues on my 03 Cobra. I noticed this when I found an intercooler pump issue, where I put a multimeter on the jumper terminals at the IC relay box and found 0 volts then turned the car on then off and got 6.8 V. I checked the 10 A fuse at the power distribution box (PDB) and...
Got in touch with a tuner in my area to resolve my running rich issue. I currently have NGK TR8IX's gapped at 0.036, but will put in TR7IX and asked the tuner for their recommendation for spark plug gap. They recommended 0.024, which I think is too small of a gap.
I'm probably running between...
Recently acquired my 03 Cobra. An issue I've noticed is that when I drive it, park it, and drive it again after sitting for several minutes (car is warm), it stutters slightly like a miss fire.
Today, it showed P0300 and 0316 as pending codes and the car started then died almost immediately...
Just bought an 03 Cobra. All I got for documentation was a dyno sheet (~480whp). I was told it has a 297 Scat stroker (~3k miles on rebuild), with a comp cam, 80lb injectors, long tube headers (no cats), JLT intake and MAF, not sure on pulley size but was told it made around 12 lbs of boost...