Hello, I have a 2014 Mustang, and I’ve had this annoying rattle by the driver side door sill for over a year now. It started out as a clunk whenever my driver side front wheel would hit bumps at low speeds. Whatever was clunking became completely loose and can now move back and forth as I...
Tried it, and there was no noise coming from inside the tire. i also looked at the joints and bushing for the sway bar, sway bar links, lower control arms, tie rod and strut, and it all looked good. No clue what it is, maybe a small rock that got in between some panels?
Sent from my iPhone...
Hmm I dont think so because the noise doesn’t happen when I am driving on a smooth road or at high speed. It happens when I hit bumps at slow speeds
Sent from my iPhone using svtperformance.com
I will need to buy a tool to tighten the top strut nut, but it seems to be tight. And I don’t have jacking rails. I’m not sure where else to look for the issue.
Sent from my iPhone using svtperformance.com
I have this bouncy rattle that seem to be coming from the driver footwell. It happens whenever I hit small bumps at slow speeds. The video I attached was recorded by placing my phone next to the driver pedals. I also recorded a video where I attached a camera to the front driver control arm, but...
I am looking for a trunk amp for a 2013-2014 mustang with the Shaker pro system. Does anyone have one for sale or know where I can purchase one?
Thank you.
So I had checked for wear, and I did not notice anything. I decided to apply some brake grease to the clips and the caliper, and now the sound is gone. I guess something was scraping a bit and making that noise.
Sent from my iPhone using the svtperformance.com mobile app
Just called my local one and they told me about $1200 just for the mufflers. What dealership was selling them for that?
Sent from my iPhone using the svtperformance.com mobile app
Well I swapped the two rear rotors to see if the sound would change sides, and it seems like it didnt. I will have to confirm with the camera. The noise happens when I am not applying the brakes, gets worse when I lightly apply the brakes, and then goes away when I hit the brakes hard. And I...
Nope, I know it’s not the brakes, the tires or the axle bearing. I’m gonna try to keep diagnosing this weekend. I am out of ideas for now
Sent from my iPhone using svtperformance.com
Hello, does anyone know where I can purchase the 2013-14 GT500 quad-tip mufflers. I see them on a few websites for about $800, but it includes the valance (which I dont need). I wanted to know if anyone has one for sale or knows where to find a better deal.
Sent from my iPhone using the...
Hello, I have had this cyclic chirping noise (I added a youtube video link), and I cannot figure out what is causing it. I set up my camera next to all my wheels and it seems like it is coming from the rear driver side wheel (or around that area. I replaced the wheel bearing for that wheel, and...
Thank you, I do believe it was something electrical. I’ve been driving the car hard, and that has not happened again since then
Sent from my iPhone using the svtperformance.com mobile app
So I checked the pins from the harness going to the amplifier (shown in picture). From ground to pin 3 and 4 I saw 6.94V on each. I then tried pin 1 and I saw about 5.86 V.
Coming out of the amp there is a cable with 8 pin, but only four are used. Between pins 4 and 3, I saw about 430 mV (when...
Drove it yesterday, and did a few pulls. Even drove up a mountain road with significant elevation change, and everything looked good. I will keep an eye on it though.
Sent from my iPhone using the svtperformance.com mobile app
Yea, I was also reading and its seems there is no actual oil temp sensor. It’s just an estimate based on other parameters
Sent from my iPhone using the svtperformance.com mobile app
I’m in New Mexico now, it was in the low 80’s °F. I did stomp on it but it was from like 50-90mph. So it seemed like a bit much
Sent from my iPhone using the svtperformance.com mobile app
So I recently bought a 2014 GT500. I did a second gear pull and I noticed that the oil temperature gauge went up significantly. It doesn’t tell me the actual oil temp, but it did raise a lot for just one pull. The oil temp did stay within the range labeled as normal. The temp went back down...
I just checked it, and the wiring looks factory and in good condition. I’m not sure where to look next
Sent from my iPhone using the svtperformance.com mobile app