Search results

I know that the IAT2 sensor wiring question has been asked a million times, and I have just spent an hour searching through threads, found a bunch from Venom 01, but all links are dead. Can someone just let me know which pins I need to connect my 2 wires from my stock 2001 IAT sensor to, in the...

I have been dealing with a tiny leak in my oil cooler for the last couple weeks, where I find just a couple drips on the garage floor. Suspecting that the oil cooler needed new o-rings and a new block flange, I went ahead and tore into it this weekend. I replaced all of the o-rings, then...

I just finished pulling my IRS, and changing all of my bushings, etc. in the midst of swapping in a 2003/2004 T56 Trans, and Driveshaft. I ended up swapping the rear flange off of my 2001 driveshaft, onto a 2003 driveshaft, running a hybrid u-joint at the rear, to make it all bolt up. I was...

I just pulled my IRS rear unit out yesterday and I am in the process of replacing all of the bushings, the tie rods, and swapping in the 2003/2004 cross brace that bolts to the rear diff. I noticed that there is a weight that hangs off of the front of the differential. I think this is a sound...

I have 99% of the parts to do the swap, just finishing up some small details like who to have tune the car, which fuel supply system to run, etc. I initially was going to keep my 2001 tank and just do the BBK 300lph drop-in pump, but found a good deal on a 2003 Tank with new dual DW300 pumps...

I am in the early stages of the Eaton swap in my 2001 Cobra, and happen to be getting my front bumper painted right now, so I thought it might be a good time to figure out what needs to be modified on the bumper support in order to mount the 2003/04 heat exchanger. I searched on here, and...

I've been searching and not able to find anything difinitive, but it looks like from the factory, there was never a gasket that went between the Intercooler coolant flange and the lower intake, is that correct? I believe that the O-rings in the tubes are what prevents coolant from leaking, not...

I'm doing some work on a customers car, it has a Kenne Bell SC on it, and has had a lot of work done. Do you all typically replace the SC to lower intake manifold gasket every time you pull the SC or is it reusable? Also, the previous shop installed the fuel injectors, but didn't install any...

I'm doing an Eaton swap on my 2001 Cobra, have most of the parts gathered, but working through some of the small details. My plan is to eliminate the EGR valve and any associated solenoids, etc. I saw these solenoids, and I wanted to see if anyone can help me identify each item on this...

I just picked up a good used 2003/2004 factory rear trunk spoiler to install onto my 2001 Convertible Cobra, and noticed that the 2003/04 spoiler has 4 or 5 studs that look to bolt through the top edge of the trunk. I just pulled the factory 3rd brake light and factory spoiler off of my 2001...

I recently purchased a 2001 Cobra Convertible, and have been working through some of the issues. Within the last 8k miles the owner put an Aluminator into the car, but the rest of the car has been pretty neglected. The car has an AJE K-member, AJE A-Arms, MM Caster/Camber plates and front...