Ended up selling my turbo sonic 2003 cobra and before I sold it went to a Whipple 3.0 setup.
Wonder racing built the engine with Todd Warren specified cams. Manual transmission 10.2 compression, ported heads and these camshafts. I don't have the cam card or cam specs. But pulled the cams to go...
I worked with JC Customs to make a limited run of 12 Stainless steel CNC'd 2003-2004 Cobra honeycomb Hood vents. This is a limited run of these. In an effort to ruin my low mileage stock cobra, I made an agreement with JC to make a short run of these and pay for them all up front.
$350 shipped...
I recently purchased a low mileage 2003 cobra anniversary edition that was completely stock. I'm going to use this thread to document the changes that I make as I progress through the build. I would like to keep the drivability and characteristics of the car stock-like. My updates will be to...
The time has come to clean out the garage of some parts that have been sitting around. All of these parts were installed on various 2003 or 20004 Cobras I have owned at one time or another. The MOST miles any of these cars had on them was 16,000 miles (one had 5,000 one 13,000). All prices are...
$10,995
Built 4.6 Teksid Engine 9.0 Compression Ratio
Fox Lake CNC Ported Heads with Oversize Valves
Pac Springs and steel retainers
Todd Warren Spec'd camshafts from Bullet Racing Cams
Forged Cobra Crank
4.6 Teksid Block cleaned .05 over with plenty of thickness left in bores. Just a cleanup...
I'm curious if anyone is running these turbos on a 4.6 based cobra engine? What kinda power are you putting down? How's the spool act? I've done a lot of searching and can't get a good answer on these.
I purchased this car about a year ago from a member and the only real thing it was lacking was a good fuel system. I had Mike Post at DynotuneMP install and dyno the fuel system along with a Holley EFI setup. He did a fantastic job with it and I'm excited with the results.
Pretty basic setup...
I'm looking for recommendations on an engine Builder in the Midwest, specifically upper Midwest if possible. Seems like shops with a grrgr reputation are in Florida, California, Texas, etc.
Should I send it to one of those shops or does someone have experience with an engine Builder in the...
As the title states, I'm in search of some DB or DC Heads, please tell me someone has some sitting around that they need to clean out of their garage!
Thanks,
Zach